Spec Data Sheet
Doc. No. :SPE070W1D1-4 v.1x Rev. No. : 0.1 Page : 28/29
This specification data sheet is an intellectual property of PowerView Display Corporation. Any copy, reproduction
or modification without written permission of PowerView Display Corporation is not allowed.
PowerView Display Corporation, http://www.powerview.com.tw
11.6.2 Appearance inspection specification
Judged
area
Judged item Inspection specification
Judge Criterion
Major Minor
Active
area
Particles,
Scratch
and
Bubbles in
display
Circular
Average diameter: D(mm) Numbers
●
D≦0.3
Disregarded
0.3 < D≦ 0.5 N≦5
0.5 < D Not allowed
Linear
Width: W(mm); Length: L(mm) Numbers
●
W≦0.1
Disregarded
0.5<L≦5.0
0.1<W≦0.2
N≦5
5.0 < L
0.2 < W
Not allowed
Bezel
Scratch
No harm
●
Dirt
●
Wrap No dangerous
●
Sunken No harm
●
Label
(S/N, B/L,
WEEK)
No label
Not Allowed
●
Overlap Label (triple)
●
Invert label
●
Broken
●
Dirt
Word can be read.
●
Not clear
●
Word out of shape
●
Mistake Not Allowed
●
Position Be attached on right position as defined in drawing
●
Screw
Not enough (Q’ty) Not Allowed
●
float Not Allowed
●
Limp Grounding OK
●
Solder Appearance
Can’t see the abnormal color, shape, hurt, dirt.
Limited sample would be prepared, if necessary.
●
Connector Connection status No correct connection
●
FPC/FFC Broken Not Allowed
●