Model No. HS1002 Owner’s Manual 1/2 Sheet Sander QUESTION... 1•847•780•6120 Visit us on the web at www.southerntechllc.com You will need this manual for safety instructions, operating procedures, and warranty. Put it and the original sales invoice in a safe, dry place for future reference.
TABLE OF CONTENTS SECTION PAGE SAFETY RULES 1 ASSEMBLY 3 PARTS ILLUSTRATION & LIST WARRANTY Amperage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2.5A Rated Power. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 320 W Paper Size. . . . . . . . . . . . . . . . . 11 x 4-1/2" (279 x 115 mm) Paper Type. . . . . . . . . . . . Hook and Loop or Non-Adhesive Dust Port. . . . . . . . . . . . . . . . . . . . . . . . .
WARNING For your own safety, read and understand all warnings and operating instructions before using any tool or equipment. WARNING Some dust created by power sanding, sawing, grinding, drilling and other construction activities contain chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • Lead from lead-based paints. • Crystalline silica from bricks and cement and other masonry products.
SPECIFIC SAFETY RULES SPECIFIC SAFETY RULES FOR SANDER 2 Be aware of general power tool safety. Make sure all the safety rules are understood. • Hold power tool by insulated gripping surfaces, when sanding where the sanding pad may contact hidden wiring or its own cord. Contact with a “live” wire may make exposed metal parts of the power tool “live” and could give the operator an electric shock. 2 ASSEMBLY • Do not wet sand with this sander. • Remove all nails from surface to be sanded.
NOTE: To remove the non-adhesive sandpaper, raise the front and rear paper clamps up and away from the tabs on the sander's base. This will release the sandpaper. • Stretch the sandpaper around the pad and slide it under the rear paper clamp. Lower rear paper clamp and lock into place behind the tab on the sander's base. ATTACHING DUST COLLECTION BOX Figure 2 Refer to Figure 4 WARNING Risk of Fire. DO NOT use the dust box when sanding metal.
ASSEMBLY DOUBLE INSULATION This tool is double insulated. Double insulated tools are equipped with a polarized plug (one blade is wider than the other). This plug will only fit in a polarized outlet one way. If the plug does not fit the outlet, reverse the plug. If it still does not fit the outlet, have a polarized outlet installed by a qualified electrician. DO NOT change the plug. Double insulated tools do not need to be grounded.
MAINTENANCE MAINTENANCE 5 • Remove the filter. WARNING Any attempt to repair or replace electrical parts on this tool may be hazardous. Repairs not listed here should be performed by a qualified service technician. • To clean filter tap it on the side of a trash receptacle or blow it with compressed air. Figure 7 WARNING To prevent serious injury from tool failure, do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
PARTS LIST 6 6 SANDER PARTS ILLUSTRATION
Key No. Part No.
WARRANTY 8 WARRANTY Thank you for investing in a POWERTEC power tool. This product has been designed and manufactured to meet high quality standards and is guaranteed for domestic use against defects in workmanship or material for a period of 12 months from the date of purchase. This guarantee does not affect your statutory rights. 8 SOUTHERN TECHNOLOGIES LLC.
NOTE
Southern Technologies, LLC 3816 Hawthorn CT, Waukegan, IL 60087