Operation Manual

POWXG3025 EN

11.4.2 Grass clearing using a grass blade

Grass blades and grass cutters must not be used on woody stems.

A grass blade is used for all types of tall or coarse grass.

The grass is cut down with a sideways, swinging movement, where the movement from right-

to-left is the clearing stroke and the movement from left-to- right is the return stroke. Let the

left-hand side of the blade (between 8 and 12 o’clock) do the cutting.

If the blade is angled to the left when clearing grass, the grass will collect in a line, which

makes it easier to collect, e.g. by raking.

Try to work rhythmically. Stand firmly with your feet apart. Move forward after the return stroke

and stand firmly again.

Let the support cup rest lightly against the ground. It is used to protect the blade from hitting

the ground.

Reduce the risk of material wrapping around the blade by following these instructions:

 Always work at full throttle.

 Avoid the previously cut material during the return stroke.

Stop the engine, unclip the harness and place the machine on the ground before you start to

collect the cut material.

11.4.3 Grass trimming with a trimmer head

11.4.3.1 Trimming (Fig. 29)

Hold the trimmer head just above the ground at an angle. It is the end of the cord that does the

work. Let the cord work at its own pace. Never press the cord into the area to be cut.

The cord can easily remove grass and weeds up against walls, fences, trees and borders,

however it can also damage sensitive bark on trees and bushes, and damage fence posts.

Reduce the risk of damaging plants by shortening the cord to 10-12 cm and reducing the

engine speed.

11.4.3.2 Clearing (Fig. 30)

The clearing technique removes all unwanted vegetation. Keep the trimmer head just above

the ground and tilt it. Let the end of the cord strike the ground around trees, posts, statues and

the like.

CAUTION! This technique increases the wear on the cord.

The cord wears quicker and must be fed forward more often when working against stones,

brick, concrete, metal fences, etc., than when coming into contact with trees and wooden

fences.

When trimming and clearing you should use less than full throttle so that the cord lasts longer

and to reduce the wear on the trimmer head.

11.4.3.3 Cutting (Fig. 31)

The trimmer is ideal for cutting grass that is difficult to reach using a normal lawn mower. Keep

the cord parallel to the ground when cutting. Avoid pressing the trimmer head against the

ground as this can ruin the lawn and damage the tool.

Do not allow the trimmer head to constantly come into contact with the ground during normal

cutting. Constant contact of this type can cause damage and wear to the trimmer head.