Operation Manual

POWX1331LI EN

9.4.3 Sanding

The removal rate and the sanding pattern are primarily determined by the choice of sanding

sheet, the pre-set oscillation rate and the applied pressure.

Only flawless sanding sheets achieve good sanding capacity and extend the service life of the

machine.

Pay attention to apply uniform sanding pressure; this increases the working life of the sanding

sheets.

Intensifying the sanding pressure does not lead to an increase of the sanding capacity, but to

increased wear of the machine and the sanding sheet.

For precise on-the-spot sanding of edges, corners and hard to reach areas, it is also possible

to work with the finger sanding pad.

When selectively sanding on the spot, the sanding sheet can heat up considerably. Reduce

the orbital stroke rate and allow the sanding sheet to cool down regularly.

A sanding sheet that has been used for metal should not be used for other materials.

9.4.4 Scraping

For scraping, select a high oscillation rate.

Work on a soft surface (e.g. wood) at a flat angle and apply only light pressure. Otherwise the

scraper can cut into the surface.

10 CLEANING AND MAINTENANCE

Before performing any work on the equipment, pull the power plug.

▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.

▪ Regularly clean the machine housing with a soft cloth, preferably after each use.

▪ Keep the ventilation slots free from dust and dirt.

▪ If the dirt does not come off use a soft cloth moistened with soapy water.

▪ Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may

damage the plastic parts.

Make sure no water can reach the inside of the power tool!