Operation Manual

ManualsBrandsPowerplus ManualsMiscellaneousPOWLI261 - LED FLOODLIGHT

POWLI261 EN

LED FLOODLIGHT WITH SENSOR 50W

POWLI261

1 DOMAIN OF USE

This outdoor lighting with a passive infra-red motion detector is the ideal outdoors security

system for your house, office, warehouse, garage, etc. It is equipped with the most

advanced passive infra-red technology to detect the heat radiation of people, animals, and

cars within a range of approximately 10 meters. In case of any movement the lamp will go

on. The period the lamp burns can be adjusted to anywhere from 5 seconds to 12 minutes.

A built-in semi darkness switch, turns off the motion sensor during those hours in order to

save energy. This also prolongs the product life of the lamp. This LED floodlight is suited

as security illumination as well as offering comfort: desired visitors will automatically

receive illumination when necessary.

WARNING! For your own safety, read this manual and the general

safety instructions carefully before using the appliance. Your LED

floodlight should only be given to other users together with these

instructions.

2 SYMBOLS

In this manual and/or on the machine the following symbols are used:

Read the manual before using the machine

In accordance with essential applicable safety standards of European

directives

3 WARNING

 The floodlight may not be attached against a mast (pole). Best installed onto a fence

or a wall, in a warehouse, shop or a similar place.

 Replace the protection glass immediately if damaged.

4 ASSEMBLY

4.1 Assemblying the floodlight

 Turn off the main circuit breaker.

 Attach this light with two screws of max. 4mm.

Summary of content (4 pages)

PAGE 1
POWLI261 EN LED FLOODLIGHT WITH SENSOR 50W POWLI261 1 DOMAIN OF USE This outdoor lighting with a passive infra-red motion detector is the ideal outdoors security system for your house, office, warehouse, garage, etc. It is equipped with the most advanced passive infra-red technology to detect the heat radiation of people, animals, and cars within a range of approximately 10 meters. In case of any movement the lamp will go on.
PAGE 2
POWLI261 EN 4.2 Wiring diagram  For mounting use a connection supply cable with N = blue, earth = green/yellow and L = brown and connect as shown in fig 3. Srew the barrel nut of the srew cap so that the packing tightens. The packing can be adjusted to a cable diameter of 8-11mm.  If you want continuous light you can add a switch. Please consult fig 4 4.3 Mounting  Check the correct way of mounting in fig 1.
PAGE 3
POWLI261 EN by setting the SENS. control knob initially to its mid-point and then adjusting the control knob clockwise to increase (up to 12 meters) the detecting distance or anti-clockwise to decrease (down to 3 meters) the detecting distance. 7 THE FIELD OF DETECTION  The field of detection of the infrared sensor can be adjusted 30 degree in horizontal direction and 30 degree in vertical direction.
PAGE 4
POWLI261 2.69kg Net weight Dimensions EN 28.3x23.3x12cm 10 ENVIRONMENT Should your appliance need replacement after extended use, do not discard it with the household rubbish but dispose of it in an environmentally safe way. Waste produced by electrical machine items should not be handled like normal household rubbish. Please recycle where recycle facilities exist. Check with your Local Authority or retailer for recycling advice. Copyright © 2016 VARO P a g e |4 www.varo.