Operation Manual

POWE80060 EN
Copyright © 2019 VARO P a g e | 8 www.varo.com
7.3.6 Cutting disc (Fig. 8)
▪ Use: Cutting or slitting bolts, screws , sheet metal, thin wood and plastic.
7.3.7 Orbital sander (Fig. 9)
▪ Use: Sanding , smoothing and shaping wood and fiberglass.
8 OPERATION
8.1 On / off switch (Fig. 10)
Always check that the power supply corresponds to the voltage on the
rating plate.
Plug the cord set into power socket, the power-on indicator (7) is illumed until the tool
disconnect from the power mains.
▪ Turning on: Turn the ON/OFF switch button (8) to position I;
▪ Turning off: Turn the ON/OFF switch button to position O.
8.2 Setting the speed (Fig. 11)
The multi tool speed is continuously adjustable. Always start from the lowest speed and then
increase the speed to the desired level.
To adjust the speed, turn the speed control dial (5). Position “1” denotes the lowest speed.
Position “MAX” denotes the highest speed. Turn the dial to increase or decrease the speed
9 CLEANING AND MAINTENANCE
Attention !Before performing any work on the equipment, pull the power
plug.
9.1 Cleaning
▪ Keep the ventilation slots of the machine clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust and dirt.
▪ If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10 TECHNICAL DATA
Rated Voltage
230V
Rated frequency
50Hz
Rated Power
135W
Rotation speed
8000-32500min
-1
Diameter Collet
2.4 – 3.2mm
Electronic speed control
Yes
Cable length
2m
Spindle lock
Yes
Soft grip
yes
Power ON LED
yes