Operation Manual

POWE10090 EN

8 CHANGING TOOLS

Unplug the tool from the power supply, only use drill spindles compatible with the tool.

8.1 Mounting chisel

CAUTION: Be sure to switch power OFF and disconnect the plug to

avoid serious trouble.

8.1.1 Inserting the tool (Fig. 3)

▪ Clean the tool before fitting it and apply a thin coating of grease to the tool shaft.

▪ Pull out the locking bolt (4) as far as possible, turn it through 180° and release it.

▪ Insert the tool into the tool chuck (5) and push it in as far as possible.

▪ Pull out the locking bolt (4) again, turn it through 180° in the opposite direction and release

it.

▪ Check the lock by pulling the tool.

8.2 Dismantling

Proceed in reverse order to mounting.

WARNING: Accessories can be hot after use. Don’t touch the tip of

accessory by hand! Please always use protective gloves to remove the

accessory.

8.3 Auxiliary handle (Fig. 4)

For safety reasons you must only use the demolition hammer with the

additional handle.

▪ The additional handle (1) enables you to achieve better stability while using the demolition

hammer.

▪ The additional handle can be turned into any required position. To do so, undo the lock

knob (8) of auxiliary handle. Then turn the handle into the most comfortable working

position and tighten the lock knob (8) again.

Important: To avoid danger, the machine must only be held using the

two handles (2-3). Otherwise you may suffer an electric shock if you

chisel into cables.

9 LUBRICATION - OIL LEVEL

Check the oil level before using the machine.

▪ Place the machine on the floor with the tool chuck (5), pointing downwards.

▪ The oil must be at least 3 mm above the bottom of the inspection window (6).

The oil should be changed after around 40-50 hours of use.

Recommended oil: 25 ml SAE 15W/40 or an alternative of the same quality.

9.1 Oil change (Fig. 5)

▪ Switch off the machine and disconnect the plug from the socket.

▪ Undo the hexagonal head screw with the inspection window (6) using the wrench (7) and

drain the oil.