Operation Manual

POW67915 EN
Copyright © 2014 VARO NV P a g e | 6 www.varo.com
11 TROUBLESHOOTING
Incidents
Causes
Remedies
Pump does not start
- No mains supply
- Floater does not
switch
- Check mains supply
- Bring floater in a higher
position
No flow
- Inlet sieve is clogged
- Pressure hose in
bent
- Clean inlet sieve water
jet
- Reset hose
Pump does not switch off
- Floater cannot sink down
- Place pump properly on shaft
ground
Insufficient flow
- Inlet sieve is clogged
- Reduced pumping
capacity by dirty and abrasive
water
- Clean inlet sieve
- Clean pump and replace
worn-out parts
Pump switches off after
short operating period
- Thermal cutout stops
pumps due to dirty water
- Water too hot.
Thermal-cutout stops pump
- Remove mains plug.
Clean pump and shaft
- Make sure that a water
temperature of max. 35°C is not
exceed
12 STORAGE
 Thoroughly clean the whole machine and its accessories.
 Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
 Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
 Don’t keep it in plastic bags to avoid humidity build-up.
13 WARRANTY
 This product is warranted as provided by law for a 24 -month period effective from the
date of purchase by the first user.
 This warranty covers all material or production flaws. It does not include defective parts
subject to normal wear & tear such as bearings, brushes, cables, and plugs, or
accessories such as drills, drill bits, saw blades, etc. ; damage or defects resulting from
maltreatment, accidents or alterations; nor the cost of transportation.
 This warranty covers all material or production flaws excluding: batteries, chargers,
defective parts subject to normal wear & tear such as bearings, brushes, cables, and
plugs, or accessories such as drills, drill bits, saw blades, etc. ; damage or defects
resulting from maltreatment, accidents or alterations; nor the cost of transportation.
 Damage and/or defects resulting from inappropriate use also do not fall under the
warranty provisions.
 We also disclaim all liability for any bodily injury resulting from inappropriate use of the
tool.
 Repairs may only be carried out by an authorised customer service centre for Powerplus
tools.
 You can always obtain more information at the number 00 32 3 292 92 90.
 Any transportation costs shall always be borne by the customer, unless agreed otherwise
in writing.
 At the same time, no claim can be made on the warranty if the damage of the device is the
result of negligent maintenance or overload.