Operation Manual

POW6016 EN
Copyright © 2013 VARO P a g e | 8 www.varo.com
place.
10.1 Automatic line feed
To lengthen the cutting wire:
 Let the tool run idle at max. speed.
 Release the switch.
 Let the spool run until it stops. At the end you will hear a “click”.
 This will automatically lengthen the cutting wire by +/- 1 cm.
11 TECHNICAL DATA
POW6016
Rated voltage 230V~
Rated frequency 50Hz
Rated Power 500W
No load speed 11000min
-
1
Cutting width 300mm
Line size Φ1.5mm
Cutting system 2 lines/automatic system
Weight 2,9kg
12 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA 83 dB(A)
Acoustic power level LwA 96 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
aw (Vibration) 3,2 m/s² K = 1,5 m/s²
13 CLEANING AND MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and regular
cleaning.
Warning! Before performing any maintenance, switch off and unplug the tool.
 Regularly clean the ventilation slot in your tool using a soft brush or dry cloth.
 Regularly clean the cutting line and spool using a soft brush or dry cloth.
 Regularly use a blunt scraper to remove grass and dirt from the underneath of the guard.