Full Product Manual

Surge Protector
Instructions
1. Set the power switch into the “OFF”
position. Plug the surge protector into
a standard grounding wall receptacle
by fully inserting the plug and ensure
that there are no exposed conductors.
2. Make sure electronic equipment is turned off before plugging into
the surge protector outlets. Do not use extension cords to connect
equipment to the surge protector.
3. Set the power switch into the “ON” position. The surge protector will
now be providing power and surge protection.
4. Connected equipment can now be turned on.
NOTE:
Check the blue “Protected” and green “Grounded” indicator lights
periodically. A glowing blue indicator light shows that surge protection is
being provided. If the blue “Protected” indicator light stops glowing, the
surge protective components have expired* and will no longer provide
surge protection. In this event, the Connected Equipment Warranty is no
longer valid and the surge protector should be replaced.
A glowing green indicator light shows that your surge protector is plugged
into a grounded receptacle. If the “Grounded” indicator light stop glowing,
it is possible the wall receptacle is no longer grounded. In this event, a
qualified electrician should be consulted to ensure the wall receptacle is
properly grounded.
Surge Protector — Limited-Lifetime Warranty
Jasco Products Company warrants this surge protector to be free of
defects in workmanship and/or materials for the life* of the surge
protector. If such a defect should arise during the life of the surge
protector, Jasco Products Company will, at its option, either repair or
replace the surge protector without charge. This warranty does not cover
damage caused by lightning, accident, misuse, or alterations to the
surge protector.
* This surge protector, like all surge protectors, has a finite lifespan. Even
under normal circumstances and in the absence of defects, the product’s
life will expire when the surge protector’s component capacity has been
exceeded, thereby ceasing to provide protection from surges. In this
event, the Limited Lifetime Warranty is no longer valid and the surge
protector should be replaced.
Warranty replacement procedure
1. Call Jasco Products Company Customer Information Center at
1-800-654-8483 to get a Return Authorization Number (RA#),
shipping instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the
Jasco Products Company surge protector, freight prepaid, to Jasco
Products Company. Surge protectors returned to Jasco Products
Company must have an RA# included in the mailing address to
be accepted.
3. The original purchaser will be asked to send the surge protector, a
copy of the sales receipt for the product, your name, address, phone
number and a description of the problem.
Connected Equipment Warranty
Equipment Replacement Guarantee for Surge Model: 12996
Maximum Warranty Amount: $200,000(USD)
NOTE:
This device is not a lightning arrestor, so it will not afford
protection when lightning strikes nearby power line, the house, service
entrance or antenna. The Warranty is void if a power disturbance
damages your equipment through the coax, phone or network lines.
Jasco Products Company will pay up to the maximum warranty amount
offered for the surge protector purchased to repair or replace up to an
amount equal to the fair market value or the original purchase price,
whichever is less, of your electronics equipment, if damaged by a
transient surge (except those caused by direct lightning), within the life*
of the surge protector, while properly and directly connected to this surge
protector. JASCO PRODUCTS COMPANY DISCLAIMS AND ASSUMES NO
LIABILITY FOR ANY OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES,
INCLUDING BUT NOT LIMITED TO LOSS OR DAMAGE TO SOFTWARE
OR DATA OR DAMAGES OR COSTS ASSOCIATED WITH BUSINESS
INTERRUPTION OR OTHER DAMAGES DUE TO LOSS OR DAMAGE
TO EQUIPMENT, SOFTWARE OR DATA. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives
you specific legal rights, and you may also have other rights that may
vary from state to state.
This warranty is secondary to any existing coverage of any connected
equipment, including but not limited to, any manufacturer’s warranty,
extended warranties, or insurance coverage.
To qualify for a connected equipment warranty:
1. All connected equipment must be UL and/or CSA approved.
2. The Jasco Products Company surge protector must be plugged into
properly wired and grounded outlets, no extension cords, adapters,
other ground wires, or electrical connectors ma be used, with the
sole exception of other standard Jasco Products Company 120 volt
products approved for that use. The installation must comply with all
applicable electrical and safety codes set forth pursuant to the National
Electrical Code (NEC).
3. Any claim under the warranty policy must be made within 15 days of
the date of the alleged damage to the connected equipment.
For connected equipment coverage, the following conditions must
be satisfied:
A) All equipment eligible for warranty coverage must be plugged directly
into the Jasco Products Company surge protector. Equipment
connected to the protected equipment, but not plugged directly into the
surge protector will not be covered.
B) The equipment must have been damaged by a covered power
disturbance that passed through the Jasco Products Company surge
protector.
C) The Jasco Products Company surge protector must be damaged from
the power disturbance.
D) The Jasco Products Company surge protector’s protection capacity
must not have been exceeded.
Connected equipment claim procedure:
1. Call Jasco Products Company Customer Information Center at 1-800-
654-8483 to get a Return Authorization Number (RA#), shipping
instructions and a prepaid return address label.
2. After you have received the prepaid return address label, return the
Jasco Products Company surge protector, freight prepaid, to Jasco
Products Company. Surge protectors returned to Jasco Products
Company, Inc. must have an RA# included in the mailing address to
be accepted.
3. Jasco Products Company will determine whether the damage to your
equipment is covered by this warranty policy. If you are covered, a
claims adjuster will contact you and Jasco Products Company will do
one of the following at its own discretion:
a) Authorize a service center to repair damaged equipment.
b) Replace damaged equipment with equivalent or better.
c) Reimburse customer the fair market value of the damaged
equipment.
d) Reimburse customer the initial purchase price of the damaged
equipment (customer to provide dated bill of sale).
4. Jasco Products Company retains the right to determine whether
the damage to the connected equipment is due to Jasco Products
Company surge protector failure by requesting that damaged
equipment be sent to Jasco Products Company for inspection.
12996 V2 6/8/16
MADE IN CHINA
Distributed by Jasco Products Company LLC,
10 E. Memorial Rd., Oklahoma City, OK 73114.
This Jasco product comes with a limited-lifetime
warranty. Visit www.byjasco.com for warranty details
and product registration.
Questions? Contact us at 1-800-654-8483 between
7:30AM—5:00PM CST.
WARNING
RISK OF ELECTRIC SHOCK
• DO NOT USE IN WET LOCATIONS
• KEEP CHILDREN AWAY
• USE INDOORS ONLY
•F ULLY INSERT PLUG
RISK OF FIRE
• DO NOT EXCEED ELECTRICAL
RATINGS
NOT FOR USE WITH
• AQUARIUMS OR OTHER WATER
RELATED PRODUCTS
• GENERATORS AND POWER INVERTERS
• MEDICAL LIFE-SUPPORT PRODUCTS