Lawn Mower User Manual

ASSEMBLY
Get off seat without moving its adjusted position,
• Raise seat and tighten adjustment bolt securely.
\
SHOULDER
BOLT
FLAT WASHER
LOCKWASHER_
ADJUSTMENT
BOLT
FIG. 2
CHECK BATTERY (See Fig. 3)
• Liftseat pan to raised position.
• If this battery is put into service after month and year
indicated on label (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BA'I-rERY" in MAINTENANCE section of this
manual for charging instructions).
LABEL
TO ROLLTRACTOR OFF SKID (See Op-
eration section for location and function of
controls)
• Press liftlever plunger and raise attachment liftlever
to its highest position.
• Release parking brake by depressing clutch/brake
pedal.
- Place freewheel control in "transmission disengaged
position" (See "TO TRANSPORT" in the Operation
section of this manual).
• Roll tractor forward off skid.
• Removebandingholdingthedeflectorshieldupagainst
tractor.
TO DRIVE TRACTOR OFF SKID (See Op-
eration section for location and function of
controls)
,_WARNING: Beforestarting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
• Be sure all the above assembly steps have been com-
pleted.
• Check engine oil level and fill fuel tank with gasoline.
• Place freewheel control in "transmission engaged"
position (see "TOTRANSPORT" in Operation section
of this manual).
• Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
• Place motion control lever in neutral (N) position.
• Press lift lever plunger and raise attachment lift lever
to its highest position.
Start the engine.After engine has started, move throttle
control to idle position.
• Release parking brake.
• Slowly movethe motioncontrol leverforward and slowly
drive tractor off skid.
Apply brake to stoptractor,set parking brake and place
motion control lever in neutral position.
• Turn ignition keyto "STOP" position.
Continue with the instructionsthat follow.
FIG. 3
NOTE: You may now rollor drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
7