ITEM #0616075 PORTFOLIO® and PORTFOLIO & DesignTM are trademarks or registered trademarks of LF, LLC. All rights reserved. MOTION-ACTIVATED WALL SCONCE MODEL #WS146W Français p. 7 Español p. 13 ATTACH YOUR RECEIPT HERE Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-643-0067, 8 a.m. - 6 p.m., EST, Monday - Thursday, 8 a.m. 5 p.m., EST, Friday.
PACKAGE CONTENTS PART DESCRIPTION QUANTITY A Fixture 1 A HARDWARE CONTENTS (shown actual size) AA BB Fixture Screw Plastic Anchor SAFETY INFORMATION READ AND SAVE THESE INSTRUCTIONS. CAUTION • Do NOT tamper with or attempt to repair LED component of fixture. The light source is designed for this specific application and should not be serviced by untrained personnel. If any servicing is required, call our customer service department.
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 10 - 15 minutes Tools Required for Assembly (not included): Phillips Screwdriver, Drill, 1/8 in. Drill Bit, Hammer, Safety Glasses, Pencil Helpful Tools (not included): Stepladder ASSEMBLY INSTRUCTIONS 1.
ASSEMBLY INSTRUCTIONS 3. Screw fixture screw (AA) into plastic anchor (BB), allowing about one thread of the screw to remain showing. 3 BB AA Hang fixture (A) on fixture screw (AA). A AA OPERATING INSTRUCTIONS 1. The fixture (A) can be used as a motion-activated light or a touch light, depending on the setting chosen. There are four different settings on the backside of the fixture (A) -- settings are as follows: 1a. OFF Light is OFF 1b.
OPERATING INSTRUCTIONS 2. The front of the fixture (A) has a motion sensor in the middle and two touch sensors, one either side. 2a A (front) 2a. Notes on MOTION Sensor: • Detects motion up to 18 in. away and within a 120° radius. • Works only when there is enough darkness. • Only functional on the 10S and 60S settings. Motion Sensor 2b.
TROUBLESHOOTING PROBLEM Light does not come on initially or no longer comes on. POSSIBLE CAUSE 1. Setting is in OFF position. 2. The ends of one or more batteries are not making contact with the terminals. 3. Batteries are old. 4. LED component is not working properly. 5. Fixture does not come on right away. CORRECTIVE ACTION 1. Make sure fixture is set to one of the three “on” settings. 2. Remove batteries and wipe ends of batteries with a cloth.