6 Foot Eco no-mizer Park Bench w/Arms For Fastener Pack (FP-EM6BA-CU-02) Congratulations ! ! You have just purchased the finest recycled plastic park bench available.
Before assembly, please make sure all components are included.
Before assembly, please make sure all fasteners are included.
Fig #1: In order to make the assembly of this Eco no-mizer Bench easier while going through the assembly process the board positions are numbered and will be referenced in later steps. Step #1: Stand (1) One bench end upright and place (1) One bench board on position 1 being sure to align the per-drilled holes to the pilot holes in the bench end. After the holes are properly aligned, fasten with (1) One #12 x 3" Flat Head Phillips Screw in the top per-drilled hole. Note: Do not tighten screw completely.
Step #2: Stand the other (2) Two bench ends upright, one at a time, and place the bench board already attached to the first bench end, on position 1 being sure to align the per-drilled holes to the pilot holes in the bench end. After the holes are properly aligned, fasten with (1) One #12 x 3" Flat Head Phillips Screw in the top per-drilled hole. Note: Do not tighten screws completely. This will be done in a later step.
Step #3: Align bottom per-drilled holes to the pilot holes in the bench end. After the holes are properly aligned, fasten with (1) One #12 x 3" Flat Head Phillips Screw per hole. Note: Be sure to tighten screws completely after this step. Step #4: Place a second bench board ow/ arm holes in position 7. Repeat Steps 1 -3 to attach. Use (1) One #12 x 3" Flat Head Phillips Screw per hole to fasten.
Step #5: Repeat Steps attach bench boards on positions 2,4, 5 & and a bench board w/arm holes in position 3. Use (1) One #12 x 3" Flat Head Phillips Screw per hole to fasten.
in the bench board w/ armholes. After the holes are Position the bench arms as shown above.
