Sideboard Assembly Instructions - Please keep for future reference WF298903 Dimensions Width - 47.2inch Depth - 11.8inch Height - 31.
! Safety and Care Advice 1 Important – Please read these instructions fully before starting assembly • Check you have all the components and tools listed on the following pages. • During assembly do not stand or put weight on the product, this could cause damage. • Remove all fittings from the plastic bags and separate them into their groups. • Assemble the item as close to its final position (in the same room) as possible.
Components - Fittings Please check you have all the hardware listed below Note: The quantitie below are the correcet amount to complete the assembly. In some cases more fittings may be supplied than are required. A B C Male Camlock(6*34) x 20 Female Camlock(15*12) x 20 Dowel x 10 D E F Shelf Support Pin x 4 Hex Key M4 x 1 6*50mm Screw x 6 G H Rebounding device x 4 I Door Hinge x 4 6*30mm Screw x 20 J K L Door Hinge x 4 3.
Using Camlocks Step 1 Connect the male camlock as diected in the assembly instructions using a scewdriver. 1 Step 2 DO NOT OVER TIGHTEN. NE PAS SERRER EXCESSIVEMENT. 2 Push the male camlock into the entry hole. 4 Step 3 3 Step 4 Insert the female camlock as shown in the instruction. Turn the female camlock clockwise with a screwdriver. Note：ensure that the arrow on the top of the camlock points towards the entry hole for the male camlock.
Assembly Instructions 4 1 7 7 6 3 7 2 7 3 12 5 8 16 15 14 13 9 11 11 10 10 9
Assembly Instructions Step 1 A A A A x 14 A A C A A A Cx4 A A A 6 A C 5 C A A A C 2 C Step 2 A C Ax2 K K C K A Cx2 K G A K K K G 1 K G G Gx4 G C K Kx8
Assembly Instructions Step 3 B Bx2 1 3 2 1 B 2 B Step 4 C Cx4 C 3 C 3 C C
Assembly Instructions Step 5 B Bx4 1 3 2 1 B B 3 2 B 3 B Step 6 A Ax4 A A 1 A A
Assembly Instructions Step 7 B Bx4 1 3 2 B 4 2 B B 3 B 3 1 Step 8 4 B 1 3 B B B B 3 Bx7 B 1 B 6 B 2 3
Assembly Instructions Step 9 B Bx3 B 1 4 3 2 B 5 1 B 3 2 3 6 Step 10 P Px2 7 7 P 7 7 P
Assembly Instructions Step 11 E Ex6 F Fx1 5 E 8 2 E E 6 E E E F Step 12 H H H F H 9 F 11 Fx1 10 11 10 H Hx8 H H 9 F H H
Assembly Instructions Step 13 H 9 H 8 H 11 H H H 11 F H Fx1 H H H H H H H x 12 9 Step 14 N Nx8 O O O O Ox6 O O N O 1 N 10 N 2 N 10 N 3 N N N
Assembly Instructions Step 15 L L x 16 L L L L L L L L L L L L L L L L L L Step 16 L D Dx4 D D D D D
Assembly Instructions Step 17 D 12 D Step 18 I Ix4 K K Kx8 K 16 I K K K K I 13 K K I I
Assembly Instructions Step 19 J Jx4 K K Kx8 K 15 K K J K K 14 J K K J J Step 20 K K x 16 I K X4 13 I K X4 J K X4 15 J J I K X4 K X4 K X4
Assembly Instructions Step 21 K K x 16 J K X4 K X4 I 16 15 K X4 J I K X4 14 13 K X4 J I K X4 Step 22 The unit is floor standing, but it is recommended that the unit is secured to the wall. 1. Move the unit into desired position. 2. Mark the wall with a suitable scribe the position of the fixing holes. Warning: ! Before driling,check wall for hidden pipes and cables. 3. Drill holes and insert 2 x wall plug 4. Attach 2 x Wall Straps to to the top of the unit using 2 x Washers and 2 x Screws 5.
Assembly Instructions Step 23 M The unit is floor standing, but it is recommended that the unit is secured to the wall. 1. Move the unit into desired position. 2. Mark the wall with a suitable scribe the position of the fixing holes. Warning: ! Before driling,check wall for hidden pipes and cables. 3. Drill holes and insert 2 x wall plug 4. Attach 2 x Wall Straps to to the top of the unit using 2 x Washers and 2 x Screws 5.
