Instructions / Assembly

frieze, rake and band boards
accessories installation
Option 3:
Determine the band board location.
Install siding to that location and then
install the band board. Nail every 8˝
to 12˝ with nails centered in slots.
Utilize field form aluminum to
adjust the location of the lineal at the
desired height.
Proceed with standard panel
application for vertical or horizontal
siding. (Fig.1)
Overlapping Lineals
Notch the back legs of the lineal to be
overlapped by making a series of cuts
as indicated in the diagram.
Cut a tapered notch into the radius at
the top and bottom of the lineal on
the end to be overlapped.
Slip the un-notched lineal 1˝ over the
notched lineal, leaving 1/2˝ for
expansion. (Fig. 3)
NOTE: For best appearance, be
sure the overlaps are away from
the direction that the house is most
commonly viewed.
8" - 12"
Fig.1
1
1
/2"
Fig. 2
37