Ar CM sensory Warming Your Home § Warming Your Hears. High Efficiency Wood Stove Large Model Series: Model Series: PH2200WS, PH2200WS-B, HES-2200, ISL-2200, ISL-2200-B, ES-2200, ES-2200-B, HES-2200-B, PEWS-2200-B, SEWS-2200, SEWS-2200-B LS-2200, GS-2200, GS-2200-B SAFETY NOTICE: IF THIS WOOD BURNING APPLIANCE IS NOT PROPERLY INSTALLED, OPERATED, AND MAINTAINED, A HOUSE FIRE MAY RESULT. TO REDUCE THE RISK OF FIRE, FOLLOW THE INSTALLATION INSTRUCTIONS.
After reading these instructions, if you have any doubt about your ability to complete your installation in a professional like manner you should obtain the services of an installer versed in all aspects as to the correct and safe installation. Do not use temporary makeshift compromises during installation. BEFORE INSTALLATION OF YOUR APPLIANCE 1. Check with the building inspector's office for compliance with local codes; a permit may be required. 2.
A WARNING This product and the fuels used to operate this product {charcoal or wood), and the products of combustion of such fuels, can expose you to chemicals including carbon black, which is known to the Slate of California to cause cancer, and carbon monoxide, which is known to the State of California to cause birth defects or other reproductive harm. For more Information go to www.pSSWarnings.ca.
INSTALLATION Contact your local building inspector prior to installation. A permit may be required in your area. 1. Remove all parts from inside the stove body. 2, Select the proper location for the stove. These appliances must not be installed any closer than the minimum clearance to combustible materials shown in Brick patter {Figure 1). The stove must be installed on a non combustible surface as shown in Figure 1. Figure 1 Clearance from Combustible Materials.
FLOOR PROTECTION INSTALLATION ON A CONCRETE FLOOR An appliance installed on a concrete floor does not require floor protection. If carpeting or any other combustible floor covering is installed, a clearance around the stove must be maintained equivalent to the size of the floor protector described in the following section.
VENTING SYSTEMS The venting system consists of a chimney connector (also known as stove pipe) and a chimney. These get extremely hot during use. Temperatures inside the chimney may exceed 2000°F (1100°C) in the event of a creosote fire. To protect against the possibility of a house fire, the chimney connector and chimney must be properly installed and maintained. An approved thimble must be used when a connection is made through a combustible wall to a chimney.