Manual
Table Of Contents
- Contents
- Introduction
- Unpacking and Checking Accessories
- Installing the Displays
- Operating the Display
- OSD Keypad
- Remote Control Receiver
- LED Indicators
- Using the Display in Portrait Mode
- Using the Display in Flat or Tilted Orientation
- Using the Remote Control
- IR Command Protocol
- Turning the Display On
- Turning the Display Off
- Adjusting the Volume
- Selecting Layouts and Input Sources
- Navigating Through the Menus
- Using the Touch Screen
- Touchscreen MultiTouch Driver Installation
- Touchscreen (PQLabs) MultiTouch Platform Content
- Uninstalling the MultiTouch Driver
- Planar UltraRes Remote Monitoring Software
- External Control
- Signal Compatibility
- Color Subsampling Support
- Specifications
- Dimensions
- Troubleshooting During Installation
- Accessing Planar’s Technical Support Website
- Index
Installing OPS Expansion (Optional)
24 Planar UltraRes Series User Manual
Installing OPS Expansion (Optional)
Planar UltraRes Series displays are equipped with an expansion slot that supports the
Intel® Open Pluggable Specification (OPS). The slot will support OPS devices such as
PC’s, SDI modules, HDBaseT receivers, etc.
To install an OPS device, remove the protective cover on the display and slide the
device firmly into position. When installed, the OPS device will be connected
internally to the display. No external video or power cables are required.
For convenience, two Type-A USB 2.0 ports and one Type-A USB 3.0 port are provided
on the side I/O panel below the OPS slot. When an OPS device is installed, these USB
ports can be used for a keyboard, webcam, USB drive, or other peripherals.