User manual

Automatically Selecting the Source
m70L Installation & Configuration Guide 27
Automatically Selecting the Source
1 Aim the remote control at the screen and press SOURCE.
a The display looks at each of the connectors and stops on the first one that is
receiving a valid picture.
b If this is successful (it may take 10 seconds) stop here.
c If you have several sources connected, press SOURCE again to go to the next
one with a picture.
d If you get no picture or have other trouble, see "Manually Selecting the
Source" on page 27.
Manually Selecting the Source
1 After the display is on, press FREQ/PHASE on the remote. This opens the PICTURE
menu.
2 Using the up/down arrows, select the SOURCE line and press ENTER.
Picture
Source Analog
Sync Type Separate H&V
Vertical Frequency (frame locked) 60Hz
Horizontal Frequency 50.00kHz
Pixel Frequency 80.10MHz
Mode ID: 31 HPer: 3178 VLines: 525
Horizontal Resolution 1366
Vertical Resolution 768
Frequency
1602
Phase
22.5°
Sharpness 4
Input Levels