Mortar Glass Block Installation System
Pittsburgh Corning Mortar Glass Block Installation System Assembly Instructions Introduction: The Mortar I System utilizes Pittsburgh Corning perimeter channels on all four sides. You will also use Universal Mortar Spacers and glass block mortar to produce clean, consistent 1/4” joints and a traditional grid look. The Mortar II System does not use the Pittsburgh Corning perimeter channels but instead utilizes expansion strips, panel reinforcing and panel anchors.
Maintenance An important part of the functional beauty of Pittsburgh Corning Glass Block products is that they are virtually maintenance free! There’s nothing to rot, rust, peel or paint.
Pittsburgh Corning Corporation 800 Presque Isle Drive Pittsburgh, PA 15239 1-800-624-2120 www.pittsburghcorning.com Weldbond ® is a registered trademark of F. T. Ross Ltd. All other trademarks and registered trademarks in this brochure are owned and protected by Pittsburgh Corning Corporation, Pittsburgh, PA 15239. © 2007 Pittsburgh Corning Corporation Printed in U.S.A. GB-243 250M Rev. 5/07 (Replaces Rev.
