User's Manual

Pepwave MAX and Surf User Manual

http://www.pepwave.com

and recommended setting is Auto.

APN / Login /

Password /

SIM PIN

When Auto is selected, the information in these fields will be filled automatically. Select

Custom to customize these parameters. The parameter values are determined by and can be

obtained from the ISP.

Bandwidth

Allowance

Monitor

Check the box Enable to enable bandwidth usage monitoring on this WAN connection for each

billing cycle. When this option is not enabled, bandwidth usage of each month is still being

tracked but no action will be taken.

Action

If email notification is enabled, you will be notified by email when usage hits 75% and 95% of

the monthly allowance. If Disconnect when usage hits 100% of monthly allowance is

checked, this WAN connection will be disconnected automatically when the usage hits the

monthly allowance. It will not resume connection unless this option has been turned off or the

usage has been reset when a new billing cycle starts.

Start Day

This option allows you to define which day of the month each billing cycle begins.

Monthly

Allowance

This field is for defining the maximum bandwidth usage allowed for the WAN connection each

month.

General Settings

Standby State

This option allows you to choose whether to remain connected or disconnected when this WAN

connection is no longer in the highest priority and has entered the standby state. When Remain

connected is chosen, bringing up this WAN connection to active makes it immediately available

for use.

Idle

Disconnect

When Internet traffic is not detected within the user-specified timeframe, the modem will

automatically disconnect. Once the traffic is resumed by the LAN host, the connection will be re-

activated.