Car Stereo System User Manual

The Setup screen appears.
4. Select ‘Information’ and press ENTER button to confirm your selection.
The Firmware Version for the Home Media Gallery is displayed.
5. Check the network settings.
Press the ↑/↓ buttons to switch the display. Each time you press ↑/↓, the display switches as follows.
6. Please write down the current firmware version of the Receiver AS WELL AS and the IP address of the
Receiver.
7. Press the top menu button to return to the top menu.
8. Open the PC’s web browser, input the IP address you noted in step 6 into the address bar/field, and then press
Enter.
The following should be displayed on the PC screen:
9. Click on the ‘Firmware Update’.
The current firmware version is displayed on the PC screen.
10. Click on the ‘OK’ button located next to the ‘Prepare for Firmware Update’.
11. Preparations for updating are performed. Follow the instructions on the screen, wait
ten or more seconds.
--If the screen does not switch, click on the “click here” on the PC screen.