Car Stereo System User Manual

ManualsBrandsPioneer ManualsTV ReceiverElite SC-27

HOME MEDIA GALLERY Firmware Update Instructions

For Models SC-25, SC-27 and SC-9540

Important

Do not turn off the Receiver, the PC being used for the update, or any network devices needed to

access the Internet or your network (such as a router) during the update process. Doing so may

damage the Receiver.

Only Microsoft Windows and Internet Explorer have been tested with this procedure. Other OS

and browsers may not properly update the Receiver.

Please end all applications on the PC before you begin the steps below to update the Receiver’s

firmware.

Please confirm the completion of the firmware update using the PC.

(If you leave the GUI screen for over five minutes, the screen saver will appear.)

Once updated, the Network settings may be restored to the factory defaults (i.e., any customized settings

may be lost).

Connecting to the Network and Internet Using the LAN Interface

Caution

Before making or changing any of the connections illustrated below, please switch off the power to the device(s)

involved and disconnect the power cord from the power outlet. Plugging in the devices to the power outlet should

be the final step.

The illustration below shows model SC-27 on the left, however the connections for models SC-25 and SC-9540

are the same except where noted.

Summary of content (5 pages)

PAGE 1
HOME MEDIA GALLERY Firmware Update Instructions For Models SC-25, SC-27 and SC-9540 Important Do not turn off the Receiver, the PC being used for the update, or any network devices needed to access the Internet or your network (such as a router) during the update process. Doing so may damage the Receiver. Only Microsoft Windows and Internet Explorer have been tested with this procedure. Other OS and browsers may not properly update the Receiver.
PAGE 2
Connect the LAN terminal on the Receiver to the LAN terminal on your router (with or without the built-in DHCP server function) with a straight LAN cable CAT5 or higher. Checking the Firmware Use the Receiver’s remote control for the following three steps: A. Press HOME MEDIA GALLERY button to select ‘Home Media Gallery’ as the input function. B. Select ‘Setup’ and press ENTER to confirm your selection. The Setup screen appears. C. Select ‘Information’ and press ENTER to confirm your selection.
PAGE 3
The Setup screen appears. 4. Select ‘Information’ and press ENTER button to confirm your selection. The Firmware Version for the Home Media Gallery is displayed. 5. Check the network settings. Press the ↑/↓ buttons to switch the display. Each time you press ↑/↓, the display switches as follows. 6. Please write down the current firmware version of the Receiver AS WELL AS and the IP address of the Receiver. 7. Press the top menu button to return to the top menu. 8.
PAGE 4
PAGE 5
The following image should now be displayed on the PC screen: 12. Click on the Browse button and open the folder that contains the firmware file you downloaded in step 1 and then select the unzipped firmware file (Do not use the .zip file). 13. Click on the ‘Upload’ button. The confirmation screen prior to updating appears, and the name of the new firmware file and other information are displayed. 14. Click on the ‘OK’ button. The firmware updating progress should be displayed on the PC screen.