DVD Recorder User Manual

ManualsBrandsPioneer ManualsDVRdvr-rt500

Getting started

Setting the audio

This section describes audio settings.

Preparation:

•Turn ON the TV and set it to the video input mode.

• Select “AUDIO” from “AV SETUP”. For the proce-

dure, see steps 1 to 3 in “Using the SETUP MENU”

on page 23.

TIMER REC SET

SYSTEM SETUP

AV SETUP

REC SETUP

CH SETUP

OTHER

AUD IO

DRC

EXTERNAL AUDIO INPUT

SAP

STD

STEREO

OFF

SETUP MENU

ENTER/

SELECT

RETURNENTER BACK END

SELECT

SETUP

DRC

DRC (Dynamic Range Control) enables you to control

the dynamic range so as to achieve a suitable sound for

your equipment.

Select “DRC” and select the level from the list below.

MAX: Full dynamic range is maintained.

STD: Full dynamic range is reduced.

TV: Dynamic range is reduced.

Note

• This function works only during playback of Dolby

Digital recorded discs.

• When you listen to the sound from TV’s speaker, we

recommend that you select “TV”.

• The level of Dynamic Range Reduction may differ

depending on the DVD.

LINE1 INPUT/LINE2 INPUT

This unit comes with an S-Video input jack and Video

input jack. When you use an S-Video or Video input jack,

you must select the input mode.

Select “LINE1 INPUT” (“LINE2 INPUT”) and select the

mode from the following list.

S-VIDEO

The video signal is input only from the S-Video input

jack.

VIDEO

The video signal is input only from the video input

jack.

Note

•You can’t record the S-video input signal to video

tape.

Setting the image quality

This section describes image quality settings.

Preparation:

•Turn ON the TV and set it to the video input mode.

• Select “AV SETUP 2” in “AV SETUP”. For the

procedure, see steps 1 to 3 in “Using the SETUP

MENU” on page 23.

TIMER REC SET

SYSTEM SETUP

AV SETUP

REC SETUP

CH SETUP

OTHER

AV SETUP 2

BRIGHTNESS

SETUP MENU

ENTER/

SELECT

RETURN SETUPENTER BACK END

STD

BRIGHTNESS

You can control the brightness level of the image.

Select “BRIGHTNESS” and select the level from the list

below.

MAX: The image becomes brighter.

STD: The image is of standard brightness.

MIN: The image becomes darker.

2D30901B_En_22_32 27/9/04, 18:1230