Installation Guide

ManualsBrandsPioneer Industries ManualsBathBrentwood Polished Chrome 2-Handle Vessel WaterSense Bathroom Sink Faucet

Installation Guide

Two Handle Lavatory Wallmount Vessel Filler:

3BR600* • 3BR700*•

3BR610* • 3BR710*•

3BR620 • 3BR720•

3BR630* • 3BR730*•

3MT600*•

This product meets the following standards:

ASME A112.18.1 •

ANSI A117.1 •

ANSI / NSF 61, SECTION 9 •

CUPC / IAPMO LISTED / *ADA COMPLIANT•

CONTAINS NO MORE THAN 0.25% WEIGHTED •

AVERAGE LEAD CONTENT

REV-01 17, 13

Engineering Excellence

Engineering E xcellence

Summary of content (7 pages)

PAGE 1
Engineering Excellence Engineering E xcellence Installation Guide Two Handle Lavatory Wallmount Vessel Filler: • • • • • 3BR600* 3BR610* 3BR620 3BR630* 3MT600* • • • • 3BR700* 3BR710* 3BR720 3BR730* This product meets the following standards: • • • • • ASME A112.18.1 ANSI A117.1 ANSI / NSF 61, SECTION 9 CUPC / IAPMO LISTED / *ADA COMPLIANT CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE LEAD CONTENT Pioneer Industries, Inc.
PAGE 2
Thank you for purchasing this Pioneer quality product. Tools Required Adjustable Wrench Teflon Tape Rags 3/32” Allen Wrench Prior to Installation • Observe all local plumbing and building codes before you begin installation. • Carefully shut off both hot and cold water supplies. • Plug the sink drain with a soft cloth to prevent intrusion of debris or the loss of any parts. • Pioneer reserves the right to make changes in the design of faucets without notice.
PAGE 3
Valve Installation • • • • • • Note:- The wall bracket (B) requires special framing and support considerations. Please pay special attention to minimum and maximum dimension recommendations noted. Refer to the specification for additional dimension information. A suggested framing example is shown. Each installation may have different framing requirements than shown. Construct the framing for your installation.
PAGE 4
Valve Installation • • • • • • • Attach the valve body (G) to the wall bracket (B) with the screws (F) and washers (E) provided. Tighten the screws (F) securely. Remove all the components (like sleeve, ceramic cartridges) to prevent internal damage. Solder the 1/2” hot (H) and cold (I) water supply lines to the valve. After soldering replace all the components removed. Position a bucket in front of the spout shank. and turn on the main water supplies.
PAGE 5
Trim Installation • • • • • • • • • • Note:- To make sure proper fit and appereance, do not oversize the spout and handle shank holes. Complete the finished wall with three 1-1/2” holes. three holes should be 4” center apart. Remove the guards (J) once the finished wall is complete. Install spout escutcheon (M). Apply plumbers putty or sealant to form watertight seal. Thread spout (N) on the spout shank (L).Install it so the spout (N) faces downword. Install handle and valve escutcheon (O).
PAGE 6
Trim Installation Drawing For more care information or trouble shooting inquiries about your Pioneer Product, please see the contact information on the back page.
PAGE 7
Engineering Excellence Engineering E xcellence 3325 S. Garfield Ave. | Commerce, CA 90040 Telephone: (800) 338-9468 | (323) 888-8873 | Fax: (323) 888-9515 Hours: M - F, 7:30am to 5:00pm PST www.pioneerind.