Retrofit Instruction

19. Place the provided ground strap over bolt #5 for the power supply, re-
install that nut, and attach the other end of the ground strap to translator rack
using the hardware supplied.
20. Plug mating AC power connectors going to the power supply and
U106T Pro amplifier together.
21. Plug mating DC power connectors going to the power supply and
U106T Pro amplifier together.
22. From the rear of the translator, attach the end of the RF cable
previously going to the cavity assembly to the UST106 Pro amplifier to the
bulkhead connector on the “RF IN” plate.
23. Mount the provided bandpass filter to the right side of the cabinet,
using the existing holes where the notch filter used to be attached.
24. Connect the RF Output cable from the UST106 Pro amplifier coming
through the cabinet to the provided bandpass filter RF Input connector.
25. Connect the provided RF Output cable from the bandpass filter to the
directional coupler.