SDS

ManualsBrandsPinalen ManualsCleaning25.3 oz. Cucumber Crush Dishwashing Liquid

Industrias AlEn

Research & Development

Safety Data Sheet

SAP Code

SDS RM-6050518

SECTION 1 – PRODUCT AND COMPANY INFORMATION

Manufacturer

Mexico emergency telephone

Fax

ALEN DEL NORTE S.A. DE C.V.

01 800 834 33 00

01 812 211 96

Address

Information telephone (US)

Blvd. Díaz Ordaz No. 1000, Los Treviño, Santa Catarina, C.P.

66150, N.L. México

CHEMTRAC

For domestic shipments

800 424 9300

For shipments outside US

703 527 3887

Product Name

PINALEN DISHLIQUID CUCUMBER CRUSH

Chemical Name

CAS Number

Synonyms/Trade Names

Application

Liquid dishwashing soap.

SECTION 2 – HAZARDS IDENTIFICATION

Classification: Eye Irritation Cat. 2B

Signal word: Warning

Hazard Statements: H320 Causes eye irritation.

Pictograms:

No pictogram required.

Precautionary Statements

 Prevention:

Avoid contact with skin, eyes and clothing. Wash hands

thoroughly after handling.

 Storage:

Keep out of reach of children. Keep

containers closed when not in use. Store

in a cool, dry area. Keep away from heat,

sparks or open flame.

Summary of content (7 pages)

PAGE 1
Industrias AlEn Research & Development 1 Safety Data Sheet SAP Code SDS RM-6050518 SECTION 1 – PRODUCT AND COMPANY INFORMATION Manufacturer Mexico emergency telephone Fax ALEN DEL NORTE S.A. DE C.V. 01 800 834 33 00 01 812 211 96 Address Information telephone (US) Blvd. Díaz Ordaz No. 1000, Los Treviño, Santa Catarina, C.P. 66150, N.L.
PAGE 2
 Response:  Disposal: Dispose in accordance with all applicable local, state and federal regulations. IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes. IF ON SKIN: Take off contaminated clothing. Rinse skin with plenty of water for 15 – 20 minutes. IF SWALLOWED: Get prompt medical attention. Give a glassful of water. Do not induce vomiting. Hazard not otherwise classified: Repeated or prolonged contact may cause skin sensitization. Unknown Toxicity: Not applicable.
PAGE 3
Wear NIOSH approved self-contained breathing apparatus and full protective clothing when fighting fires involving chemicals. Special firefighting procedures Use water spray to keep containers cool. Conditions to avoid Heat, sparks, open flame and other sources of ignition. Hazardous combustion products Carbon monoxide and carbon dioxide.
PAGE 4
Appropriate engineering controls: Ventilation requirements General ventilation X Local ventilation Unnecessary in normal cond. Work practices: Follow good manufacturing practices for housekeeping and personal hygiene. Wash any exposed skin immediately after and chemical contact before breaks and meals, and ta the end of each work period. Contaminated clothing and shoes should be thoroughly cleaned before re-use.
PAGE 5
SECTION 11 – TOXICOLOGICAL INFORMATION Information on the likely routes of exposure Contact via Acute Chronic Ingestion May cause irritation to intestinal mucous. NA Inhalation None under normal use conditions None under normal use conditions. Skin May cause irritation on sensitive skin. Repeated or prolonged contact may cause an allergic skin reaction. Eyes Causes eye irritation.
PAGE 6
SECTION 15 – REGULATORY INFORMATION RCRA (40 CFR 261, Subpart D): New Jersey List: Right to Know Hazardous Substance Not applicable. This product contains the following components subject to reporting requirements: benzene sulfonic acid. Clean Water Act: Pennsylvania Hazardous Substance List: Benzene sulfonic acid containing material regulated under sections 301, 307, 311 RQ=100 lbs/45.4 Kg. This product contains the following components subject to reporting requirements: benzene sulfonic acid.
PAGE 7
DISCLAIMER The submission of this MSDS may be required by law, but this is not an assertion that the substance is not hazardous when it is not used in accordance with proper safety practices and normal handling procedures. Data supplied is for use only in connection with occupational safety and health. The information contained herein has been compiled form sources considered by Industrias AlEn to be dependable and is accurate to the best of the Company’s knowledge.