Datasheet

Relays for functional safety
Safety relays PNOZsigma
PNOZ s50
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: [phone], Telefax: [phone], E-Mail: [e-mail]
2016-09
914
Save PNOZ s50 configuration on the computer
1. Make a note of the configuration's CRC in the PNOZ s50. It is shown on the display in
the Information/ Configuration CRC menu. This will be needed later to check whether
the correct configuration is saved on the device.
2. Remove the chip card from the PNOZ s50 and insert it into the holder for the chip card
reader.
3. Start the SmartCardCommander software.
4. Insert the holder containing the chip card into the chip card reader.
5. The Memory Card directory is displayed in a list under Hardware on the software inter-
face of the SmartCardCommander.
6. To read the data on the chip card, click on the Memory Card directory and then select
Read Data from Card.
7. When Data read successfully is displayed on the software interface, the data can be
saved as a hex file in any directory on the computer.
8. Make sure that the corresponding configuration CRC, which you noted down, is saved
in the same directory.
Download configuration from the computer to the PNOZ s50
1. Insert a chip card into the holder for the chip card reader and insert this into the chip
card reader.
2. Start the SmartCardCommander software.
3. To write the chip card, select Write Data to Card and confirm with Yes.
4. Insert the chip card in the PNOZ s50.