Instructions for use

G2
GP2
GP1
CA
G2
GP2
GP1
G2A
CA
Glue the G2A to the Strut and
G2, But do not glue the GP2
and GP1 to the Strut in this time.
G3
Glue the G3 to the G2A
CA
Adjust the GP2 and GP1
before glue them to the G1.
Glue the GP2 and GP1to
the Strut.
G1
G3
CA
CA
G2A
G1
G2
G1
GP 2
GP 1
GP 2
GP 1
G2A
G2
Wheel Cover Parts
3mm plywood
3mm screw set
Gear door
Wooden ringStrut
Sand here
Sand here
Lightly sand the wooden rings to be sure that
the struts locks in retracted position.
10- STRUT AND GEAR DOOR ASSEMBLY
P-47 THUNDERBOLT
11- STRUT AND GEAR DOOR ASSEMBLY
P-47 THUNDERBOLT
Important: When you “on” the retract swicth,
if the retract gear does not retracted completely,
use your finger to push the retract gear to the
completely retrated position, it will extend.
Then use the hobby knife to remove the place
where the retract gear is entangled.