Instructions for use

PITTS Item code: BH85-A Instruction Manual
5
 3) Using the thread as a guide and using mask-
ing tape, tape the servo lead to the end of the thread:
carefully pull the thread out. When you have pulled the
servo lead out, remove the masking tape and the servo
lead from the thread.
Drill a hole
1.5mm
Secure
Electric wire
 4) Place the servo into the servo tray. Center
the servo within the tray and drill 1.5mm pilot holes
through the block of wood for each of the four mount-
ing screws provided with the servo.
Electric wire
Drill a hole
1.5mm
2x10mm
Secure
 5) Repeat the procedure to install the aileron
servos in the other wing half.
3. INSTALLING THE AILERON CONTROL HORN
 1) Remove the covering from the slot on the bot-
tom of the aileron.
 2) Insert the control horn into the slot and secure
it by A+B Epoxy glue.
1. A+B Epoxy glue
2. Push in
Aileron
control horn
4. INSTALLING THE AILERON LINKAGES
 3) Repeat the procedure to install the
control horn on the other aileron.
Installing the aileron linkages as pictures below.
100mm
Snap keeper.
M2 lock nut
Bend
Silicone tube