Instructions for use

PITTS Item code: BH85-A Instruction Manual
2
 Some more parts.
 HARDWARE PACK
 COWLING.
 Landing gear.....
This instruction manual is designed to help you build a great ying aeroplane. Please read this manual thoroughly
before starting assembly of your PITTS. Use the parts listing below to identify all parts.
Please trial fit all the parts. Make sure you have
the correct parts and that they t and are aligned
properly before gluing! This will assure proper
assembly. PITTS ARF is hand made from natural materi-
als, every plane is unique and minor adjustments may have
to be made. However, you should nd the t superior and
assembly simple.
The painted and plastic parts used in this kit are fuel
proof. However, they are not tolerant of many harsh
chemicals including the following: paint thinner, C/A
glue accelerator, C/A glue debonder and acetone. Do
not let these chemicals come in contact with the colors
on the covering and the plastic parts.
FUSELAGE ASSEMBLY
 (1) Fuselage.
WING ASSEMBLY
 (1) Right wing half with pre-installed aileron.
 (1) Left wing half with pre-installed aileron.
TAIL SECTION ASSEMBLY
 (1) Vertical stabilizer with pre-installed rud-
der.
 (1) Horizontal stabilizer with pre-installed
elevator halves.
To avoid scratching your new airplane, do not
unwrap the pieces until they are needed for
assembly. Cover your workbench with an old towel or
brown paper, both to protect the aircraft and to protect
the table. Keep a couple of jars or bowls handy to hold
the small parts after you open the bag.
SUGGESTION
NOTE
Please be aware that this aeroplane is not a toy and if assembled or used incorrectly it is capable of causing
injury to people or property. WHEN YOU FLY THIS AEROPLANE YOU ASSUME ALL RISK & RESPONSIBILITY.
If you are inexperienced with basic R/C ight we strongly recommend you contact your R/C supplier and join your
local R/C Model Flying Club. R/C Model Flying Clubs offer a variety of training procedures designed to help the new
pilot on his way to successful R/C ight. They will also be able to advise on any insurance and safety regulations
that may apply.
WARNING
 Thick cyanoacrylate glue.
 30 minute epoxy.
 5 minute epoxy.
 Hand or electric drill.
 Assorted drill bits.
 Modelling knife.
 Straight edge ruler.
 2mm ball driver.
 Phillips head screwdriver.
 220 grit sandpaper.
 90° square or builder’s triangle.
 Wire cutters.
 Masking tape & T-pins.
 Thread-lock.
 Paper towels.
TOOLS & SUPPLIES NEEDED
PARTS LISTING