Datasheet

For further information and full technical data, visit phoenixcontact.net/products
163PHOENIX CONTACT
Terminal blocks - CLIPLINE complete
ST... spring-cage connection terminal blocks
The reducing bridge allows terminal
blocks with different nominal cross sections
to be connected with ease. The reducing
bridge can be used to quickly create power
blocks, e.g., an ST10 spring-cage terminal
block with an ST2,5 or ST4.
The double function shaft can be used to
connect any number of terminal blocks with
two-position bridges. The 2- to 50-pos.
bridges allow up to 50 terminal blocks to be
bridged in one step.
A jumping bridge is created by removing
individual contact guides from the standard
bridge. Two potentials can then be routed
in parallel. The contact points can also be
marked.
The P-FIX isolated feed-through
connector, P-DI isolating plug, P-CO
component connector, and P-FU cartridge
fuse plug can be used in the universal plug-
in zone of the disconnect terminal block.
A test plug with a 2.3mm diameter is
available for measuring lines. All
measurement and test work can be
completed at speed using test adapters for
4mm diameter test plugs and the modular
test plugs.
The hybrid versions combine the benefits
of the spring-cage connection method with
those of the universal screw connection.
The partition plates protrude beyond the
terminal block contours. They provide
visual as well as electrical group separation.
Cover segments are used to cover
protruding terminal block segments of
three- or four-conductor terminal blocks,
when adding two-conductor terminal
blocks. Fingers are thereby protected from
contact.
ST-COMBI terminal blocks are available
for creating plug-in signal and power wiring.
The system is touch proof and offers plugs
for self-assembly with extensive
accessories. See “COMBI” section, page
225.