Datasheet

For further information and full technical data, visit phoenixcontact.net/products
81PHOENIX CONTACT
Terminal blocks - CLIPLINE complete
PT... push-in connection terminal blocks
The reducing bridge allows terminal
blocks with different nominal cross sections
to be connected with ease, e.g., a PT10
push-in terminal block to a PT2,5. Power
blocks can be created quickly using the
reducing bridge.
The double function shaft can be used to
connect any number of terminal blocks with
two-position bridges. The 2- to 50-pos.
bridges allow up to 50 terminal blocks to be
bridged in one step.
A jumping bridge is created by removing
individual contact guides from the standard
bridge. Two potentials can then be routed
in parallel. The contact points can also be
marked.
The P-FIX isolated feed-through
connector, P-DI isolating plug, P-CO
component connector, and P-FU cartridge
fuse plug can be used in the universal plug-
in zone of the disconnect terminal block.
A test plug with a 2.3mm diameter is
available for measuring lines. All
measurement and test work can be
completed at speed using test adapters for
4mm diameter test plugs and the modular
test plugs.
As well as offering a testing facility in the
double function shaft, all push-in technology
terminal blocks offer an additional test
contact for test plugs with a 2.3 mm
diameter.
Push-in COMBI terminal blocks are
available for the plug-in configuration of
signal wiring. The system is touch-proof and
offers plugs for self-assembly with extensive
accessories.
Automatic flat-type fuse terminal blocks
with a 4mm conductor connection are
available in the same shape as the feed-
through terminal blocks. All terminal blocks
can be continuously bridged with one
another with the double function shaft.
The compact lever-type fuse terminal
blocks are of the same shape as the feed-
through terminal blocks and can be printed
and bridged continuously. A time-saving
potential distribution is easily created using
bridging between non-adjacent terminal
blocks.