Datasheet

For further information and full technical data, visit phoenixcontact.net/products
27PHOENIX CONTACT
Terminal blocks - CLIPLINE complete
UT... screw connection terminal blocks
The reducing bridge enables terminal
blocks with different nominal cross sections
to be connected easily, e.g., a UT10
terminal block to a UT2,5. Power blocks
can be created quickly using the reducing
bridge.
The double function shaft can be used to
connect any number of terminal blocks with
two-position bridges. The 2 to 50-pos.
bridges allow up to 50 terminal blocks to be
bridged in one step.
A jumping bridge is created by removing
individual contact guides from the standard
bridge. Two potentials can then be routed
in parallel. The contact points can also be
marked.
The P-FIX isolated feed-through
connector, P-DI isolating plug, P-CO
component connector, and P-FU cartridge
fuse plug can be used in the universal plug-
in zone of the disconnect terminal block.
A test plug with a 2.3mm diameter is
available for measuring lines. All
measurement and test work can be
completed at speed using test adapters for
4mm diameter test plugs and the modular
test plugs.
Large-surface and clear marking of the
terminal points is essential for reliable and
quick installation. Each terminal point in the
UT... series can be marked separately.
Disconnect terminal blocks and feed-
through terminal blocks UT4-MTD are
available in the same shape as the feed-
through terminal blocks. All terminal blocks
can be continuously bridged with one
another with the double function shaft.
If fully wired, the level offset of the
double-level terminal blocks allows the
lower connection level to be accessed in full
and provides a perfect view of the lower
labeling markers and conductor entry
funnel.
UT-COMBI terminal blocks are available
for creating plug-in signal and power wiring.
The system is touch proof and offers plugs
for self-assembly with extensive
accessories. See “COMBI” section, page
225.