Datasheet

https://www.phoenixcontact.com/us/produkte/2903342
Nov 13, 20132/13
Relay Module-RIF-1-RPT-LDP-24DC/1X21-2903342
Technical data
Contact side
Min. switching current
10 mA (at 12 V)
Limiting continuous current
11 A (refer to the diagram)
Interrupting rating (ohmic load) max.
264 W (at 24 V DC)
Interrupting rating (ohmic load) max.
58 W (at 48 V DC)
Interrupting rating (ohmic load) max.
48 W (at 60 V DC)
Interrupting rating (ohmic load) max.
50 W (at 110 V DC)
Interrupting rating (ohmic load) max.
80 W (at 220 V DC)
Interrupting rating (ohmic load) max.
2750 VA (for 250 V AC)
Switching capacity in acc. with DIN VDE 0660/IEC 60947
2 A (24 V (DC13))
Switching capacity in acc. with DIN VDE 0660/IEC 60947
6 A (230 V (AC 15))
Connection data
Connection method
Push-in connection
Conductor cross section solid min.
0.14 mm²
Conductor cross section solid max.
1.5 mm²
Conductor cross section stranded min.
0.14 mm²
Conductor cross section stranded max.
1.5 mm²
Conductor cross section stranded, with ferrule with plastic
sleeve min.
0.14 mm²
Conductor cross section stranded, with ferrule with plastic
sleeve max.
1.5 mm²
Conductor cross section stranded, with ferrule without plastic
sleeve min.
0.14 mm²
Conductor cross section stranded, with ferrule without plastic
sleeve max.
1.5 mm²
Conductor cross section AWG/kcmil min.
26
Conductor cross section AWG/kcmil max
16
Stripping length
8 mm
General
Type of note
Notes on operation
Note
FBS 2-6... plug-in bridge for the input side (A2) and FBS-2-8...
plug-in bridge for the output side (11/21)
Test voltage relay winding/relay contact
4 kV
rms
(50 Hz, 1 min.)
Operating mode
100% operating factor
Degree of protection
IP20 (Relaissockel)
Degree of protection
RT III (relay)
Mechanical service life
Approx. 3 x 10
7
cycles
Standards/regulations
DIN EN 50178
Standards/regulations
IEC 62103
Rated surge voltage / insulation
6 kV/safe isolation
Rated insulation voltage
250 V AC
Pollution degree
2
Surge voltage category
III