Information

nanoNavigator sample program
2337_en_A PHOENIX CONTACT 1-1
1 nanoNavigator sample program
1.1 Introduction
Welcome to the nanoLine Controller Quick Start Guide. This document will guide you
through the process of configuring a nanoLine controller (nanoLC) to perform a simple,
example application. Starter Kit (Part No. 2701399) includes all the components to
simulate this and many other applications.
The example application, shown graphically in Figure 1-1, simulates a water tank with
a valve to control the flow of water into the tank as the contents are drained out through
a separate pipe. The nanoLC monitors the level of the water in the tank through a
sensor and opens or closes a valve to keep the water at the proper level.
Figure 1-1 Example nanoLC application
This example uses one of the red switches (input) included with the nanoLC starter kit
to simulate a sensor in the water tank. When the switch is ON, it will mean that the
water is at the proper level and the inlet valve must be turned off. If the switch is OFF,
it will mean that the water has drained below the proper level and the inlet valve must
PWR
RUN
12
nanoLine
OK
SHIFT
5
0
6
1
7
2
8
3
9
4
Inlet Valve
Level
Sensor
nanoLC
base unit