Observation Camera ENGLISH This device complies with part 15 of the FCC rules, Operation is subject 10 the following two conditions: 1. this device may not cause harmful interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. This device is intended to be attached fo a receiver that is not used to receive over the-air broadest signals.
Table of contents Page Introduction Protective caver Video out The lens Cable Tips for maintenance. Introduction Your new CCD camera is specially developed for use with a special observation system monitor. It features a sensitive microphone thus. registering both images and sound via the monitor. Installation Warning: A When a camera Or accessory is connected or disconnected, the monitor should always be disconnected from the mains Supply. Only operating the stand-by key is not sufficient.
Sound if required, the microphone incorporated In the camera, can be switched ff, (fig. A-13). 1 an intercom box is included in the camera fine, the sound of camera and intercom box wil be reproduced by the monitor. Position First you need to determine where the camera is to be installed. The jest results are obtained when the camera looks a lite downwards and not into a bright source of light.
The lens Caution: Do not touch the glass of the fens. This could damage the delicate coating on its surface. i the lens has to be cleaned, uses special lens cleaning tissue, available at any good camera store. Focus range 3.8 men: The built-in fens provides an optimal image sharpness for objects between 1 meter and infinity (depth of field. Focus range 8 mm: The lens has a mania! focus, adjustable from 0.5 m to infinity.
Cable A 4-wire system cable {see specifications) is supplied standard. For an optimum picture and sound quality a standard “twisted-pair’ {telephone} cable shouts be used. There is an extensive range of plugs and fools available in the hobby and professional fared to extend the cable. Always pay attention that the connection corresponds to figure B. Remark: Used system cables and connectors are similar to the ones used for telephone, but may not be interconnected.
Technical specification COD CAMERA VCMB935/00T [VCMBI36/007] Pick-up device 13" {Solid state CCD} No. of picture elements (H) x (V) 262 x 582 (CCIRY/362 x 492 (E14) Horizontal resolution > 280 TVL Light sensitivity 2.5 ~ lux Spectral sensitivity range 400 ~ 1000 nm Signal to noise ratio »>48dB Culprit ANV RJ 11 £ modular “briefer” socket Built-in microphone electron Lens type built-in Lens viewing angle 4.4 x 49.6°V [31°H x focal length 38mmBmm] relative aperture Faro {fetus range 1 ~ 010 Macro .05 0.