Shortusermanual

Corded phone
TD2801
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips
N.V. and are used under license. This product has been manufactured by and is sold
under the responsibility of MMD Hong Kong Holding Limited or one of its affiliates,
and MMD Hong Kong Holding Limited is the warrantor in relation to this product.
2023
© MMD Hong Kong Holding Limited. All rights reserved. Speci�cations are
subject to change without notice.
TD2801_QSG_V1.0
1 Answer a call: When the phone rings, pick up the
handset to answer the call.
4 Mute function: When on a call, press and hold the
"Mute" key on the left of the handset, the other
party will not hear you. Release the key to return to
the call.
Working conditions
Ambient temperature: 0℃ to 40℃
The total distortion caused by harmonic
intermodulation is at least 20dB lower than the
fundamental level
5 Adjust the ringer volume or turn the ringer off: Use
the ringer switch on the right of the handset to
adjust the ringer volume or turn the ringer off.
7 Transfer a call: This service is network dependent.
Check with service provider for additional charges.
6 Pause while dialing: The " " key of this phone
has dual functions: redial and pause. Before you dial
a number, press the key to redial. While you are
dialing, press the key to enter a pause.
If the subscriber you dialed is busy, hang up the
handset to end the call, then press " " to redial the
number. (Note: The purpose of inserting a pause is to
isolate the prompt tone. Each time the key is pressed,
a delay of 3 seconds will be added before the phone
dials the number)
Note: When a new number is stored in a memory
location of a key, the old number will be
automatically deleted.
3 Memory dialing: For speed dialing, this phone can
store phone numbers respectively in the memory
locations of "1-9, 0, " keys. Operation
as follows:
Store numbers into memory: Pick up the handset
→ press " " → enter a number (e.g. 63541088)
→ press " " → press any key ("1-9, 0, M1, M2, M3")
for the memory location where you want to store
the number → Hang up. (To facilitate the dialing,
please write down the numbers stored in the
memory on the writing paper on the base station)
Direct memory dialing: Pick up the handset and
press " ” key to dial the corresponding
number stored.
2 Make a call: Pick up the handset and dial the
number you want to call. If you hear a busy tone,
hang up the handset to end the call. Redial the number
or press the “ ” key to make the call again.
1 To wall mount the phone, drill two screws into wall
vertically. The distance between the screws is 10cm.
Hang the base station on the screws. (See �gure below)
Install height: no heigher than 2.0M
2 Plug the other end of the handset coil cord into the
telephone socket on the wall. Connection is successful
when you hear a signal tone.
3 To hold a call, hang the handset on the call hold hook
on the base station.
Wall mount
screw
Memo paper
Wall mount
screw
Rotary knob
for hook
Standby hook
Call hold hook
(for handset)
»
»
Indirect memory dialing: Pick up the handset →
press " " → press a number key ("1-9, 0") to dial
the corresponding number stored.
»
Make a �rst call.
»
Make a second call.
»
Hang up the handset when the other side answers
the call. The �rst call is transferred to the second
call.
»
Press during a call.
»
Warning
Your product is designed and manufactured
with high quality materials and components,
which can be recycled and reused.
This symbol means the product must not be
discarded as household waste and should be
delivered to an appropriate collection facility
recycling.
Care of the environment
Disposal of your old product .
•
The electrical network is classi�ed as hazardous. The only
way to power down the charger is to unplug the power
supply from the electrical outlet. Ensure that the electrical
outlet is always easily accessible.
• Refer to safety information before using the product.
• Hereby, TP Vision Europe B.V. declares that the product is
in compliance with the essential requirements and other
relevant provisions of RED Directive 2014/53/EU and UK
Radio Equipment Regulations SI 2017 No 1206. You can
�nd the Declaration of Conformity on
www.philips.com/support.
• Use only the power supply listed in the user instructions.
Use only the batteries listed in the user instructions.
Do not allow the product to come into contact with
liquids.
Dispose of used batteries according to the instructions.
When the handset rings or when the handsfree is
activated, keep the handset away from your ear to avoid
hearing damage.
SAR value <0.1 W/kg
Information on the safety of users and non-users:
Compliance with speci�c usage restrictions on certain
places (hospitals, planes, petrol stations, schools...).
Precautions to be taken by electronic implants wearers
(cardiac stimulators, insulin pumps, neurostimulators...),
concerning in particular the distance between the radio
equipment and the implant (15 centimeters in the case of
the strongest sources of exposure such as mobile phones).
Information on the behaviors to follow to reduce
exposure to radiation emitted by equipment:
Use your device in good reception conditions to reduce the
amount of radiation received. Make reasoned use of radio
equipment, such as mobile phones by children and teens,
for example by avoiding night-time communications and
limiting the frequency and duration of calls. Keep radio
equipment away from the womb of pregnant women.
Keep radio equipment away from teenagers’ lower
abdomens.
•
•
•
•
•
•
www.philips.com/welcome
What‘s in the box
Get started
3
Technical dataOperate
4
7
6
5
4
3
2
1
8
10
11
12
13
9
1 Microphone
2 3 speed dial keys
3 Number keys
4 Settings
5 Extract
6 Hook switch
7 Earpiece
8 Redial
9 Transfer
10 Incoming call indicator
11 Ringer switch
12 Ringer speaker
13 Mute
Overview
1
Connect
2
To access the user
instructions online,
use the reference
model number written
on the product label
at the bottom of the
base station.
www.philips.com/support
Frequently asked questions
No display
Make sure there are power and phone connections.
The service is not activated. Check with your
service provider.
The caller’s information is withheld or unavailable.
Make sure your phone is properly connected to the
line cord.
Make sure the handset is properly connected to
the base through the coil cord.
No dialing tone
No voice from the receiver
or no voice transmission
The caller ID does not display
Risk of strangulation. Keep away from children.
This product is not a toy.
Sound
Ringtones: High, Low, Off
Convenience
LED: Yes, for incoming call
Wall mountable
Memory Capacity
Speed dial: M1, M2, M3
Memory dial: 10
Memory in total: 13