Party Speaker 4000 Series TAX4207 User manual Register your product and get support at www.philips.
Contents 1 Important safety instructions Safety Care for your product Care of the environment Compliance Help and support Hearing safety Built-in battery care Trademarks 2 Your party speaker What’s in the box Party speaker 3 Get started Connect to power Turn On and Off Volume control DBB control Charge the built-in battery Change light effect Play from Bluetooth devices Pairing for stereo mode (TWS) Party link mode Play audio through USB Listen to an external device Sing through microphone Factory reset Upd
1 Important safety instructions Read and understand all instructions before you use your product. If damage is caused by failure to follow instructions, the warranty does not apply. • • • Safety • Know these safety symbols • CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
• • If the product is transported in temperatures below 5°C, unpack the product and wait until its temperature matches room temperature before connecting it to the power outlet. Parts of this product can be made of glass. Handle with care to avoid injury and damage. Risk of overheating! • Never install this product in a con ned space. Always leave a space of at least four inches around the product for ventilation. Ensure curtains or other objects never cover the ventilation slots on the product.
Hearing safety • • • Listen at a moderate volume • • To establish a safe volume level Listen for reasonable periods of time Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss. Sound can be deceiving.
FCC information NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2 Your party speaker hones Headphon Series CTN hones Headphon Series CTN Congratulations on your purchase, and welcome to Philips! To fully bene t from the support that Philips offers, register your party speaker at www.philips.com/support.
Party speaker 8 9 10 11 12 14 15 16 17 18 13 This section includes an overview of the party speaker. 1 2 3 4 5 6 19 7 1 Light key • Press to change speaker light mode. • Press and hold for 3 sec to change speaker light brightness 2 DBB key • BASS effect setup. 3 Volume- key • Decrease the volume. 4 Volume+ key • Increase the volume. 5 Play/Pause key • Start, pause or resume play. • Press and hold for 3 seconds to skip the next track.
Voice changer button • Press repeatedly to switch among different voice tones: Woman voice/ Man voice/Children voice/Normal effect. 10 Party link button 3 Get started When you use this unit for the rst time or unused for long periods of time, recharge the battery fully. • Press to enter party link pairing mode. Note 11 TWS pair button • Press to enter True Wireless Stereo (TWS) pairing mode. • It work only when you have two identical speakers.
Turn On and Off Press and hold key for 3 seconds to switch on/off the unit. Note • The speaker will turn off automatically after 15 minutes without user operations and music playback. Charge the built-in battery Plug the AC power cord to charge the built-in battery. The battery indicators blink in different manners to indicate the charging status. Note • The four indicators on the unit will go out in 15 seconds after the battery is fully charged.
• The speaker is designed with a smart battery check feature for your convenience. • Press button to show the current battery level on the LED indicators of the unit in power on mode while the unit is not being charged. Change light effect Turn speaker light on or off 1 In power on mode, press (Light) key repeatedly to switch among different light modes of speaker light. Note • When the battery level is low, all battery LED indicators will blink simultaneously and a prompt tone is heard.
Play from Bluetooth devices 5 To exit Bluetooth, you can: • • The product can stream music from your Bluetooth device to the system through Bluetooth. Note • • A Bluetooth device which supports Bluetooth • • • pro le A2DP, AVRCP and with Bluetooth version as 5.0 + EDR. The maximum operational range between the party speaker and a Bluetooth device is approximately 30 meters. The player will also be disconnected when your device is moved beyond the operational range.
» Pairing for stereo mode (TWS) » Two speakers can pair with each other for stereo sound. Note The rst speaker entered TWS mode is master and LED3 on master speaker turns sold blue. The volume level, play/pause state, light mode in slave speaker will sync from master speaker after TWS connected. 3 To exit TWS, press and hold (TWS) button on either speaker. • TWS is worked only if there are two identical party speakers (Philips TAX4207).
Key & Operate » Action Press and hold key Change brightness in all speakers on either speaker for 3 seconds Exit TWS mode Press and hold button on either speaker for 3 seconds Volume level, play/pause state, light mode in slave speakers will sync from master speaker after PartyLink connected. 5 Press and hold PartyLink button on master speaker. All speakers will exit PartyLink mode. Note PartyLink mode The speaker can connect up to 50 party speakers together and play audio at the same time.
Key & Operate Action key Press on master speaker Select Play/pause the music on all connected speakers Press VOL + /－ key on master speaker Increase or decrease volume on all connected speakers Press DBB key on master speaker Change DBB setting on all speakers Press and hold power key on master speaker for 3 seconds Power off master speaker, all slave speakers will exit party link mode Press and hold key on selected slave speaker for 3 seconds Power off selected slave speaker, there is no effect on
Listen to an external device Sing through microphone With this product, you can listen to an external audio device such as an MP3 player. Adjust microphone volume Play from an MP3 player 1 Connect an audio input cable (not supplied) with a 3.5mm connector on both ends to: • The Audio in socket on the unit. • The headphone socket on the MP3 player. Connect a microphone (not supplied) into the Mic in socket of the unit, and adjust the microphone volume by turning the Mic vol knob.
4 Product speci cations Extension Codec MPEG 1 Layer 1 16 ~ 48 kHz 32 ~ 448 kbps MPEG 1 Layer 2 16 ~ 48 kHz 8 ~ 384 kbps MPEG 1 Layer 3 16 ~ 48 kHz 8 ~ 320 kbps MPEG 2 / MPEG 2.5 16 ~ 48 kHz Layer 1 8 ~ 256 kbps MPEG 2 / MPEG 2.5 16 ~ 48 kHz Layer 2 8 ~160 kbps MPEG 2/ MPEG 2.5 16 ~ 48 kHz Layer 3 8 ~ 160 kbps .wav WAV 16 ~ 48 kHz Up to 1536 kbps .wma WMA 8 ~ 48 kHz 5 ~ 320 kbps FLAC Up to 48 kHz / 16 bit Note • Speci cations and design are subject to change .mp3 without notice.
5 Troubleshooting Cannot display some files in USB device • Note • Never remove the casing of the product. To keep the Warranty valid, never try to repair the system yourself. If you encounter problems when using this unit, check the following points before requesting service. If the problem remains unsolved, go to the Philips website (www.philips.com/support). When you contact Philips, ensure that your unit is nearby and the model number and serial number are available.
Speci cations are subject to change without notice. Please visit www.Philips.com/support for the latest updates and documents. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used under license. This product has been manufactured by and is sold under the responsibility of MMD Hong Kong Holding Limited. or one of its af liates, and MMD Hong Kong Holding Limited. is the warrantor in relation to this product. TAX4207YW_UM_EN_V1.
