Headphones 4000 Series TAK4206 User manual Register your product and get support at www.philips.
Contents 1 Important safety instructions 2 Hearing Safety General information 2 2 2 Your Bluetooth wireless headphones What's in the box Other devices Overview of your Bluetooth wireless headphones 3 Get started Charge your headphones Pair the headphones with your mobile phone 4 Use your headphones Reconnect the headphones to a Bluetooth device Manage your calls and music Wear your headphones Playtime limit and volume limit 3 3 3 3 4 4 4 5 5 5 6 6 5 Technical data 8 6 Notice 9 Declaration of
1 Important safety instructions Hearing Safety Danger To avoid hearing damage, limit the time you use headphones at high volume and set the volume to a safe level. The louder the volume, the shorter the safe listening time is. Be sure to observe the following guidelines when using your headphone. • Listen at reasonable volumes for reasonable periods of time. • Be careful not to adjust the volume continuously upwards as your hearing adapts.
2 Your Bluetooth wireless headset Global Warranty Safety leaflet Other devices Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/support. With this Philips wireless headset, you can: • enjoy convenient wireless handsfree calls; • enjoy and control wireless music; • switch between calls and music. A mobile phone or device (e.g.
3 Get started earliest paired device is replaced by the new one. 1 Charge the battery Note Before you use your headset for the first time, charge the battery for 5 hours for optimum battery capacity and lifetime. Use only the original USB charging cable to avoid any damage. Finish your call before charging the headphones, as connecting the headphones off. You can’t operate the headphones normally during charging.
4 Use your headphones Manage your calls and music On/off Reconnect the headphones to a Bluetooth device Turn on your mobile phone/Bluetooth device. Press and hold for 2 seconds to turn the headphones on. Task Turn the headpnones on. Turn the headpnones off. Button The blue light on. The headphones are reconnected to the last connected mobile phone/Bluetooth device automatically. If the headphone can not connect to last device within 1 min, enter “Not Connected” mode.
RGB light mode indicator Wear your headphones Task Red light mode Button Operation Press once. Adjust the headband to fit your head. Blue light mode Press once. Green light mode Press once. Rainbow light mode Press once. Light off Press once. Other headphones indicator status Headphones status The headphones are connected to a Bluetooth device, while the headphones in standby mode or while you are listening to music The headphones are ready for pairing.
• A voice prompt saying ‘Playtime limit enabled’ will be heard 10mins before the volume reaches the pre-set volume limit. a) When the playtime limit is reached, voice prompt ‘Playtime limit enabled’ plays and the music in the headphones will be paused. The voice prompt ‘Playtime limit enabled’ will play every 10sec until the battery runs out.
5 Technical data Settings ! 70% > Volume Limit Playtime Limit 30 min > > Product information Software update 30 min > > About Home Settings Settings ! Settings 70% > Volume Limit ! 30 min > Playtime Limit 30 min > Playtime Limit > Product information 70% > Volume Limit > Product information Playtime Limit Volume Limit 30 min > Software update Software update 30 min 30 min > 50% > About 1 hr 2 hr 70% 3 hr 80% 4 hr 90% Never Never Done Home > About 60% Settings Ho
6 Notice Declaration of conformity Hereby, MMD Hong Kong Holding Limited declares that this product is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. You can find the Declaration of Conformity on www.p4c.philips.com. Remove the integrated battery If there is no collection/recycling system for electronic products in your country, you can protect the environment by removing and recycling the battery before disposing the headphones.
Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment.
Caution: The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Avis de conformité Cet appareil satisfait aux règlements de la FCC partie 15 du Code of Federal Regulations. Son fonctionnement est assujetti aux deux conditions suivantes: 1. Cet appareil ne doit pas causer d’interférence préjudiciable et 2.
7 Trademarks Bluetooth The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Top Victory Investment Limited is under license. Other trademarks and trade names are those of their respective owners.
8 Frequently asked questions Make sure your mobile phone not only supports (mono) HFP but also supports A2DP (see “Technical data” on page 7 ).
UM_TAK4206_00_EN_V1.
