Instructions for use

English

3 Check whether all the keys are working.

For an overview of the keys and their

functions see ‘3. Keys and functions’.

– If the TV responds as it should to all of the

key commands the SRU560 is ready for use.

• If the device does not respond at all or not to all of the

key commands, follow the instructions under

‘Setting the remote control’, or for online setup go to:

www.philips.com/urc.

Setting the remote control

This is only necessary if your device does not respond to the SRU560.

If that is the case, the SRU560 does not recognize the brand and/or model of

your device and you need to program the remote control to do so.

The example below (TV) instructs you how to do this.You can repeat the

same steps for other devices (DVD, video recorder, etc.) which you want to

operate using the SRU560.

Automatically setting the remote control

The remote control will now automatically search for the right code for your

device.

Example of TV:

1 Make sure the TV is switched on and select a channel using the original

remote control or the keys on the TV (for example channel 1).

The SRU560 emits the ‘switch off TV’ signal for all models of TV that are

stored in the memory.

• If the device is a DVD-player/recorder or video recorder, insert a disk or

tape and start playback.

2 Press the SELECT key to select TV.

Press the key until the Standby key lights up.

3 Then keep keys 1 and 3 pressed

simultaneously for three seconds until the

Standby key flashes twice and then remains lit.

4 Press and hold the Standby key

of the SRU560.

– The SRU560 now starts emitting all known

‘TV off’ signals, one by one.

Each time a code is sent, the Standby key

lights up.

5 When your TV switches off (stand-by), release

the Standby key of the SRU560 immediately.

SRU560_87_v6.qxd 26-04-2005 15:08 Pagina 5