operation manual

here to help: GB: 0844 33 80 489 national call rate (mobiles vary)
IRL: 0818
21 01 41 national call rate (mobiles vary) AU: 1300 364 474
www.philips.com/Avent
thoroughly and that the surfaces are clean before contact with sterilised
components. Assembly When you assemble the bottle, make sure you
place the cap vertically onto the bottle so that the teat sits upright. To remove
the cap, place your hand over the cap and your thumb in the dimple of the
cap. The teat is easier to assemble if you wriggle it upwards instead of pulling
it up in a straight line. Make sure you pull the teat through until its lower par t
is even with the screw ring. MaintenanceBefore rst use place in boiling
water for 5 minutes. Before each use, inspect all items. Pull the feeding
teat in all directions. For optimum performance, pinch and massage the
number on the teat between index nger and thumb prior to a feed. Throw
away at the rst signs of damage or weakness. For hygiene reasons, we
recommend replacing teats after 3 months. Keep teats in a dry, covered
container. When not in use, do not store in sunlight or heat, or leave in
disinfectant (sterilising solution) for longer than recommended, as this may
weaken the teat. Do not place in a heated oven. GlassNaturalbottle
Glass bottles may break. Do not use metal inside the bottle to stir contents or
for cleaning. This can damage the glass on the inside of the bottle. Before each
use, inspect bottles for sharp edges or glass fragments inside. Do not use
bottles if there are any cracks on or glass fragments in the bottle. Do not let
babies drink unsupervised with this bottle. Compatibility Only use Philips
Avent Natural teats with Philips Avent Natural feeding bottles. Spare teats are
available separately. Make sure you use a teat with the correct ow rate when
you feed your baby. When you use an older Philips Avent steriliser, please
check on the website how to place the Natural bottle. Do not mix classic
bottle parts and teats with parts of the Natural bottle. They may not t and
could cause leakage. The polypropylene Natural bottle is compatible with
Philips Avent breast pumps, spouts, sealing discs and cup tops. The glass
Natural bottle is compatible with Philips Avent breast pumps and sealing discs.
For safety reasons, it is not recommended to use glass Natural bottles with
handles, spouts and cup tops. If the bottle falls, it may break. Philips Avent is
GB
ForyourchildssafetyandhealthWARNING!
Always use this product with adult supervision. Never use feeding teats as a
soother. Continuous and prolonged sucking of uids will cause tooth decay.
Always check food temperature before feeding. Keep all components not
in use out of the reach of children. Before rst use, clean the product.
Inspect before each use and pull the feeding teat in all directions. Throw away
at the rst signs of damage or weakness. Do not store a feeding teat in direct
sunlight or heat, or leave in disinfectant (sterilising solution) for longer than
recommended, as this may weaken the teat. Do not place in a heated oven.
Before rst use place in boiling water for 5 minutes. This is to ensure
hygiene. Clean before each use. Wash and rinse thoroughly, then sterilise
using a Philips Avent steriliser or boil for 5 minutes. Do not warm contents
in a microwave oven, as this may cause uneven heating and could scald your
baby. Dishwasher safe - food colourings may discolour components. Do
not allow child to play with small parts or walk/run while using bottles or cups.
Drinks other than milk and water, such as fruit juices and avoured sugar y
drinks are not recommended. If used, they should be well diluted and only
used for limited periods. Expressed breast milk can be stored in sterilised
Philips Avent polypropylene bottles/containers in the refrigerator for up to 48
hours (not in the door) or in the freezer for up to 3 months. Never refreeze
breast milk or add fresh breast milk to already frozen milk. Do not use
abrasive cleaning agents or anti-bacterial cleaners. Do not place components
directly on surfaces that have been cleaned with anti-bacterial cleaners.
Excessive concentration of detergents may eventually cause plastic
components to crack. Should this occur, replace immediately. Plastic
material proper ties may be affected by sterilising and high temperatures. This
can affect the t of the cap.CleaningBefore rst use, disassemble all parts,
clean and sterilise the product. After every use, take all items apart, wash in
warm soapy water and rinse thoroughly. Make sure that you wash your hands
www.philips.com/avent
Philips Consumer Lifestyle BV
Tussendiepen 4, 9206 AD Drachten,
Netherlands
Trademarks owned by the Philips Group.
©2015 Koninklijke Philips N.V.
All rights reserved
here to help: GB: 0844 33 80 489 national call rate (mobiles vary)
IRL: 0818
21 01 41 national call rate (mobiles vary) AU: 1300 364 474
www.philips.com/Avent
thoroughly and that the surfaces are clean before contact with sterilised
components. Assembly When you assemble the bottle, make sure you
place the cap vertically onto the bottle so that the teat sits upright. To remove
the cap, place your hand over the cap and your thumb in the dimple of the
cap. The teat is easier to assemble if you wriggle it upwards instead of pulling
it up in a straight line. Make sure you pull the teat through until its lower par t
is even with the screw ring. MaintenanceBefore rst use place in boiling
water for 5 minutes. Before each use, inspect all items. Pull the feeding
teat in all directions. For optimum performance, pinch and massage the
number on the teat between index nger and thumb prior to a feed. Throw
away at the rst signs of damage or weakness. For hygiene reasons, we
recommend replacing teats after 3 months. Keep teats in a dry, covered
container. When not in use, do not store in sunlight or heat, or leave in
disinfectant (sterilising solution) for longer than recommended, as this may
weaken the teat. Do not place in a heated oven. GlassNaturalbottle
Glass bottles may break. Do not use metal inside the bottle to stir contents or
for cleaning. This can damage the glass on the inside of the bottle. Before each
use, inspect bottles for sharp edges or glass fragments inside. Do not use
bottles if there are any cracks on or glass fragments in the bottle. Do not let
babies drink unsupervised with this bottle. Compatibility Only use Philips
Avent Natural teats with Philips Avent Natural feeding bottles. Spare teats are
available separately. Make sure you use a teat with the correct ow rate when
you feed your baby. When you use an older Philips Avent steriliser, please
check on the website how to place the Natural bottle. Do not mix classic
bottle parts and teats with parts of the Natural bottle. They may not t and
could cause leakage. The polypropylene Natural bottle is compatible with
Philips Avent breast pumps, spouts, sealing discs and cup tops. The glass
Natural bottle is compatible with Philips Avent breast pumps and sealing discs.
For safety reasons, it is not recommended to use glass Natural bottles with
handles, spouts and cup tops. If the bottle falls, it may break. Philips Avent is
GB
ForyourchildssafetyandhealthWARNING!
Always use this product with adult supervision. Never use feeding teats as a
soother. Continuous and prolonged sucking of uids will cause tooth decay.
Always check food temperature before feeding. Keep all components not
in use out of the reach of children. Before rst use, clean the product.
Inspect before each use and pull the feeding teat in all directions. Throw away
at the rst signs of damage or weakness. Do not store a feeding teat in direct
sunlight or heat, or leave in disinfectant (sterilising solution) for longer than
recommended, as this may weaken the teat. Do not place in a heated oven.
Before rst use place in boiling water for 5 minutes. This is to ensure
hygiene. Clean before each use. Wash and rinse thoroughly, then sterilise
using a Philips Avent steriliser or boil for 5 minutes. Do not warm contents
in a microwave oven, as this may cause uneven heating and could scald your
baby. Dishwasher safe - food colourings may discolour components. Do
not allow child to play with small parts or walk/run while using bottles or cups.
Drinks other than milk and water, such as fruit juices and avoured sugar y
drinks are not recommended. If used, they should be well diluted and only
used for limited periods. Expressed breast milk can be stored in sterilised
Philips Avent polypropylene bottles/containers in the refrigerator for up to 48
hours (not in the door) or in the freezer for up to 3 months. Never refreeze
breast milk or add fresh breast milk to already frozen milk. Do not use
abrasive cleaning agents or anti-bacterial cleaners. Do not place components
directly on surfaces that have been cleaned with anti-bacterial cleaners.
Excessive concentration of detergents may eventually cause plastic
components to crack. Should this occur, replace immediately. Plastic
material proper ties may be affected by sterilising and high temperatures. This
can affect the t of the cap.CleaningBefore rst use, disassemble all parts,
clean and sterilise the product. After every use, take all items apart, wash in
warm soapy water and rinse thoroughly. Make sure that you wash your hands
www.philips.com/avent
Philips Consumer Lifestyle BV
Tussendiepen 4, 9206 AD Drachten,
Netherlands
Trademarks owned by the Philips Group.
©2015 Koninklijke Philips N.V.
All rights reserved
here to help: GB: 0844 33 80 489 national call rate (mobiles vary)
IRL: 0818
21 01 41 national call rate (mobiles vary) AU: 1300 364 474
www.philips.com/Avent
thoroughly and that the surfaces are clean before contact with sterilised
components. Assembly When you assemble the bottle, make sure you
place the cap vertically onto the bottle so that the teat sits upright. To remove
the cap, place your hand over the cap and your thumb in the dimple of the
cap. The teat is easier to assemble if you wriggle it upwards instead of pulling
it up in a straight line. Make sure you pull the teat through until its lower par t
is even with the screw ring. MaintenanceBefore rst use place in boiling
water for 5 minutes. Before each use, inspect all items. Pull the feeding
teat in all directions. For optimum performance, pinch and massage the
number on the teat between index nger and thumb prior to a feed. Throw
away at the rst signs of damage or weakness. For hygiene reasons, we
recommend replacing teats after 3 months. Keep teats in a dry, covered
container. When not in use, do not store in sunlight or heat, or leave in
disinfectant (sterilising solution) for longer than recommended, as this may
weaken the teat. Do not place in a heated oven. GlassNaturalbottle
Glass bottles may break. Do not use metal inside the bottle to stir contents or
for cleaning. This can damage the glass on the inside of the bottle. Before each
use, inspect bottles for sharp edges or glass fragments inside. Do not use
bottles if there are any cracks on or glass fragments in the bottle. Do not let
babies drink unsupervised with this bottle. Compatibility Only use Philips
Avent Natural teats with Philips Avent Natural feeding bottles. Spare teats are
available separately. Make sure you use a teat with the correct ow rate when
you feed your baby. When you use an older Philips Avent steriliser, please
check on the website how to place the Natural bottle. Do not mix classic
bottle parts and teats with parts of the Natural bottle. They may not t and
could cause leakage. The polypropylene Natural bottle is compatible with
Philips Avent breast pumps, spouts, sealing discs and cup tops. The glass
Natural bottle is compatible with Philips Avent breast pumps and sealing discs.
For safety reasons, it is not recommended to use glass Natural bottles with
handles, spouts and cup tops. If the bottle falls, it may break. Philips Avent is
GB
ForyourchildssafetyandhealthWARNING!
Always use this product with adult supervision. Never use feeding teats as a
soother. Continuous and prolonged sucking of uids will cause tooth decay.
Always check food temperature before feeding. Keep all components not
in use out of the reach of children. Before rst use, clean the product.
Inspect before each use and pull the feeding teat in all directions. Throw away
at the rst signs of damage or weakness. Do not store a feeding teat in direct
sunlight or heat, or leave in disinfectant (sterilising solution) for longer than
recommended, as this may weaken the teat. Do not place in a heated oven.
Before rst use place in boiling water for 5 minutes. This is to ensure
hygiene. Clean before each use. Wash and rinse thoroughly, then sterilise
using a Philips Avent steriliser or boil for 5 minutes. Do not warm contents
in a microwave oven, as this may cause uneven heating and could scald your
baby. Dishwasher safe - food colourings may discolour components. Do
not allow child to play with small parts or walk/run while using bottles or cups.
Drinks other than milk and water, such as fruit juices and avoured sugar y
drinks are not recommended. If used, they should be well diluted and only
used for limited periods. Expressed breast milk can be stored in sterilised
Philips Avent polypropylene bottles/containers in the refrigerator for up to 48
hours (not in the door) or in the freezer for up to 3 months. Never refreeze
breast milk or add fresh breast milk to already frozen milk. Do not use
abrasive cleaning agents or anti-bacterial cleaners. Do not place components
directly on surfaces that have been cleaned with anti-bacterial cleaners.
Excessive concentration of detergents may eventually cause plastic
components to crack. Should this occur, replace immediately. Plastic
material proper ties may be affected by sterilising and high temperatures. This
can affect the t of the cap.CleaningBefore rst use, disassemble all parts,
clean and sterilise the product. After every use, take all items apart, wash in
warm soapy water and rinse thoroughly. Make sure that you wash your hands
www.philips.com/avent
Philips Consumer Lifestyle BV
Tussendiepen 4, 9206 AD Drachten,
Netherlands
Trademarks owned by the Philips Group.
©2015 Koninklijke Philips N.V.
All rights reserved

Summary of content (3 pages)