User manual

Important notes for users in the UK

This set complies with the radio interference requirements of the

European Union.

Mains plug

This apparatus is fitted with an approved 13 Amp plug.To change a fuse in this

type of plug proceed as follows:

1. Remove fuse cover and fuse.

2. Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.

3. Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an

appropriate plug fitted in its place. If the mains plug contains a fuse, this should

have a value of 5 Amp. If a plug without a fuse is used, the fuse at the

distribution board should not be greater than 5 Amp.

Note:The severed plug must be disposed of to avoid a possible shock hazard

should it be inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue =

neutral (N), brown = live (L). As these colours may not correspond with the

colour markings identifying the terminals in your plug, proceed as follows:

• Connect the blue wire to the terminal marked N or coloured black.

• Connect the brown wire to the terminal marked L or coloured red.

• Do not connect either wire to the earth terminal in the plug, marked E (or e)

or coloured green (or green and yellow).

• Before replacing the plug cover, make certain that the cord grip is clamped

over the sheath of the lead - not simply over the two wires.

Recording and playback of material may require consent. See Copyright Act

1956 and The Performer’s Protection Acts 1958 to 1972.

CAUTION!

Apparatus shall not be exposed to dripping or splashing. Do not place any

sources of danger on the appartus (e.g. liquid filled objects,lighted candles)

PET810_ENG.QXD 4/25/05 9:26 AM Page 2