operation manual

15
English
EN
6 Update software
Philips continually tries to improve its products.
To get the best features and support, update your
home theater with the latest software.
Compare the version of your current software with
the latest version on www.philips.com/support. If
the current version is lower than the latest version
available on the Philips support website, upgrade
your home theater with the latest software.
Caution
•
Do not install a lower version of software than
the current version installed on your product.
Philips is not liable for problems caused due to
software downgrade.
Check software version
Check the version of the current software installed
on your home theater.
1 Press SETUP.
2 Select [Preference Setup] and then press OK.
3 Select [Version Info.] and then press OK.
» The software version is displayed.
Update software through USB
What you need
• A USB ash drive that is FAT-formatted, with
at least 75MB of memory. Do not use a USB
hard drive.
• A computer with Internet access.
• An archive utility that supports the ZIP le format.
Step 1: Download the latest software
1 Connect a USB ash drive to your computer.
2 In your web browser, go to
www.philips.com/support.
3 At the Philips Support website, nd your
product and locate the Software and drivers.
» The software update is available as a zip le.
4 Save the zip le in the root directory of your
USB ash drive.
5 Use the archive utility to extract the software
update le in the root directory.
6 Disconnect the USB ash drive from your
computer.
Step 2: Update the software
Caution
•
Do not switch off the home theater or remove
the USB ash drive during the update.
1 Connect the USB ash drive containing the
downloaded le to your home theater.
• Make sure that the disc compartment is
closed and there is no disc inside.
2 Switch your TV to the correct source for
your home theater.
3 Follow the onscreen instructions to conrm
the update.
» Once complete, the home theater
automatically switches off and restarts. If
it does not, disconnect the power cord
for a few seconds and then reconnect it.