Software Upgrade

Instruction
ForupgradeviaaUSBflashdrive:
1.Extractthefirmwareupgradefilefromthedownloadedfirmwarepackage.
2.Copytheextractedfirmwarefile(e.g.HTL1190.Bin)totherootdirectoryintheUSBflashdrive.
3.Turnonthedeviceandsourceswitchto‘BT’,‘OPT’,‘COAX’or‘Audioin’mode
(Not‘AUX’mode
and‘USB’mode).
4.InserttheUSBflashdriveintotheUSBslot.
5. Source switch to ‘AUX’ mode by remote control, then switch to ‘USB’ mode within 60 sec,
systemwillautomaticallyupgradewithallLEDsturningon.
6. The device will automatically reboot and switch
source to ‘AUX’ mode after successfully
upgrade.
7.Doubleconfirmyoursoftwareversionvia:
SwitchtoMUTEstatus,andthenquicklypress“AUX”keyfortwotimeswithin800ms(<800ms)by
Remotecontrol,thedevicewillshowsoftwareversionfor3sec,ifthesoftwareversioniscorrect,
theupgradeis
successful.
PhilipsHTL1190BseriesFWversiondisplaySpecification
Ver:0.2

C1 C2 FWVERSION
LEDPosition STANDBY COAXIAL
OPTICAL AUX AUDIOIN USB
HEX DEC

Off Off
Off Off Off Off
00 00
 Off Off Off On 01 01
 Off Off On Off 02 02
 Off Off On On 03 03
 Off On Off Off 04 04
 Off On Off On 05 05
 Off On On Off 06 06
 Off On On On 07 07
 On Off Off Off 08 08
 On Off Off On 09 09
 On Off On Off 0A 10
 On Off On On 0B 11
 On On Off Off 0C 12
 On On Off On 0D 13
 On On On Off 0E 14

On On On On
0F 15

Off On
Off Off Off Off
10 16
 Off Off Off On 11 17
 Off Off On Off 12 18
 Off Off On On 13 19