DreamStation Go Heated Humidifier Manual

9
4. Remove the tank lid by pulling up on the tank lid tab
while holding the tank base. Pour out any remaining
water and rinse the tank base.
5. Place the tank base on a rm, at surface. Fill the
tank base with water no higher than the maximum
ll line .
Note
The water level may rise in the tank base when the
tank lid is attached.
6. Reassemble the water tank. Align the tank lid with
the tank base (1). Push down on the tank lid (2) until
the tab on the tank lid snaps securely over the hook
on the tank base (3). When the tank lid is attached
correctly there should be no gap between the tank
lid and the tank base (4).
4
7. Slide the water tank back into the humidier. Ensure
that it is fully connected before proceeding.
Note:
A pop-up message will appear if the water
tank is not fully connected.
Warning
When installing the tank, do not allow any water
to spill into the humidier or therapy device.
8. Attach the tubing connector to the air outlet port. If
you are not using a 12mm tube, use the 15mm/22mm
tube adapter.
9. Supply power to your therapy device. Refer to the manual included with your therapy device.
10. Put on your mask assembly. Refer to the instructions supplied with your mask.
11. Turn on the airow on your device and begin
therapy. Refer to the manual included with your
therapy device for instructions on how to turn
therapy on and o.
Caution
Do not turn the humidier on without the water tank
installed. The humidier setting must be “0” (o) if
there is no water in the water tank.
Note
If you are having trouble with your mask, refer to the
instructions included with the mask.