HD7826, HD7824, HD7820
IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed including the following: Read all instructions before using the appliance. 1. Do not touch hot surfaces. Use handles or knobs. Care must be taken to prevent burns which can occur from touching hot parts or spilling hot liquids. 2. To protect against fire, electrical shock and injury to persons, do not immerse cord, plug, or appliance in water or other liquid. 3.
17. To prevent scalds and/or property damage, always make sure Coffee Machine lid is securely in place and properly locked before you start using the machine and during brew cycle. Do not force when opening or closing lid. 18. Do not open lid until Coffee Machine has finished brew cycle. Hot steam or hot water trapped under lid cover could burn your fingers. 19. Warning:To reduce the risk of fire or electric shock, do not remove the bottom cover. No user serviceable parts are inside.
WARNING: - To avoid risk of personal injury or damage to property as a result of overflow, be sure that the cup or mug is centered under the coffee outflow unit during the brew cycle. - Brewed coffee and coffee pods are very hot. Handle with care to avoid scalding. - If coffee spout overflows or fails to drain into cup/mug during brewing cycle, do not open lid or handle coffee spout or coffee pod holder(s). Unplug Coffee Machine and wait for contents to cool before handling.
TABLE OF CONTENTS General description 6 Introduction 7 Preparing the machine for use 7 Brewing coffee 9 Cleaning 12 Descaling 15 Storage 16 Assistance 16 Troubleshooting 16 Warranty 19
General description (Fig.
Introduction With Douwe Egberts SENSEO\ coffee pods, you can enjoy a perfect cup of coffee at any time of the day. Every cup is freshly brewed to give you that smooth and full taste. Using more than 250 years of coffee expertise Douwe Egberts has roasted and ground specially selected coffee beans that, when prepared using a special brewing method co-developed with Philips, ensure a full, smooth taste and delicious foam layer. This joint creation, known as the SENSEO\ coffee pod system, consists of the Phi
2 Fill the water reservoir with cold water up to the MAX indication and put it back onto the machine. 3 Release the lid by moving the lever upwards. 4 Open the lid. 5 Put the 1-cup pod holder q or the 2-cup pod holder qq in the machine without pod(s). 6 Close the lid and lock the lever. Note:Make sure the lever is properly locked by pushing it down until it snaps home with a click. Note:Never flush the machine with the lid open.The lid must be properly locked.
8 Put a bowl (with a capacity of at least 1.6 qt./ 1.5 litres) under the spout openings to collect the water. 9 Press the on/off button 3. Type HD7826/HD7824 only: after pressing the on/off button, the light rings around the 1-cup button q and the 2-cup button qq/w burn continuously. 10 Press the 1-cup button q AND the 2-cup button qq briefly at the same time. The boiler fills itself with water from the water reservoir. This may take some time (approx. 90 to 150 seconds).
2 Press the on/off button 3. The indicator light blinks slowly while the water is heating up. Heating up takes approx. 75 seconds. , The coffee machine is ready for use when the indicator light burns continuously. If the indicator light blinks rapidly, the water reservoir does not contain enough water for brewing one cup of coffee. , Type HD7826/HD7824 only: the light rings around the 1-cup button q and the 2-cup button qq/w also go on when the machine is ready for use.
, , Place 2 SENSEO\ coffee pods in the 2-cup pod holder qq. , , , , , , , , , , , , , , , 7 Close the lid and lock the lever. Always check if the lid is properly locked. The lever must be pushed down until it snaps home with a click. Never start brewing with the lid open. The lid must be properly closed. 8 Place one cup or two cups under the spout openings.You can adjust the height of the coffee spout by sliding it upwards or downwards.
two cups. To obtain two full cups, fill the water reservoir and press the 1-cup button q. The two cups will then be filled completely. Note: If you only get a small quantity of coffee or no coffee at all out of the machine, you have not flushed the machine properly before first use. As a result, the boiler is not or not completely filled. Flush the machine properly (see chapter ‘Preparing the machine for use’) before you brew another cup of coffee.
, You can disassemble the coffee spout for more thorough cleaning! 5 Clean the coffee spout, the coffee collector and the drip tray in hot water, if necessary with some dish soap, or in the dishwasher. 6 Hold the cup tray in your hand while cleaning it with hot water, if necessary with some dish soap. The cup tray can also be cleaned in the dishwasher. To clean the cup tray, always remove it from the machine, as it might prove sharp when handled incorrectly. Always handle it carefully.
9 Do not use an object with sharp edges to clean the water inlet on the machine. 10 Rinse the parts with fresh water after cleaning and put them back into the machine. 11 Clean the water distribution disc with a moist cloth. Be careful when you do this; make sure that the rubber sealing ring does not get stuck under the edge of the water distribution disc.
5 Press the on/off button 3 (1) and subsequently press buttons the 1-cup button q and the 2-cup button qq/w briefly at the same time (2). The machine fills itself with water from the water reservoir. While this happens, water comes out of the spout. When the flushing cycle is finished, the machine switches itself off. During the flushing cycle, the machine produces more noise than during a regular brewing cycle . Never interrupt the flushing cycle halfway.
2 Fill the water reservoir up to the MAX indication with the descaler mixture. Then put the water reservoir back into the coffee machine. Note: Not all SENSEO\ machine types have a water reservoir with a capacity of 1 litre. If you have a SENSEO\ machine with a smaller water reservoir, repeat steps 2 to 6 with the remainder of the mixture without filling the water reservoir up to the MAX indication. 3 Press the on/off button 3.
Storage If the coffee machine has already been used and therefore has been flushed with water, it may only be used and stored in a frost-free place to prevent it from becoming damaged. Empty water resorvoir before storing. Assistance For assistance, call toll free: 1-866-473-6736 or visit our website: www. senseo.com Information is available 24 hours a day, 7 days a week. Troubleshooting If you have a problem, you may find the solution in the table below.
Problem Solution the sieve in the centre of the pod holder is not clogged. If it is, unclog the sieve by holding the pod holder under a running tap. If necessary, you can use a washing-up brush or a pin to unclog the sieve; the coffee pod has been put properly in the centre of the pod holder; the sealing ring has not got stuck under the edge of the water distribution disc (see figure 1 at the beginning of these instructions for use).
Problem Solution The machine has been stored in a room that was not frost-free. Contact the Philips Consumer Care Centre in your country. The SENSEO\ coffee is not strong enough. Make sure that: you have used the correct number of pods and have pressed the right button. Use 1 pod in combination with the 1-cup pod holder q and the 1-cup button q.
FULL TWO YEARS WARRANTY Philips Electronics North America Corporation warrants each new Philips Product, model HD7826/7824/7820 (except cord, coffee pods and accessories) against defects in materials or workmanship for a period of two years from the date of purchase, and agrees to repair or replace any defective product without charge.
4222.200.0010.
