Quick start guide

There are many ways to connect your new DVD/VCR to your Television and other equipment.This Quick-Use

Guide shows the easiest, most common connection.

Higher quality connections are explained in the accompanying owner’s manual and will provide better sound

or picture if your TV and/or audio system is compatible.

REAR OF TV

(EXAMPLE ONLY)

OUT

ANTENNA IN

AUDIO IN

VIDEO IN

Audio Cables

RF COAXIAL CABLE

Video Cable

Audio and Video IN Jacks on TV

Antenna or Cable TV Signal to ANT-IN Jack

CABLE BOX

(Optional)

CABLE TV SIGNAL

ANTENNA or

CABLE TV SIGNAL

DVP3050R

Disconnect all equipment from the power outlets. Connect the equipment to the power outlets only after you

have finished hooking up everything. Never make or change connections with equipment connected to the power outlet.

Connect your Antenna TV signal or, if you have a Cable Box/Satellite Receiver, the OUT jack of your Cable

Box/Satellite Receiver to the ANT-IN jack on the rear of the DVD/VCR using the supplied RF coaxial cable.

Connect another RF coaxial cable (not supplied) to the DVD / VCR’s ANT-OUT jack and to your TV’s

ANTENNA IN jack.

The TV’s ANTENNA IN jack may be labelled 75-ohm,TV IN, or RF IN. Check your TV manual for details

Connect the red and white audio cables (supplied) to the red and white DVD/VCR AUDIO OUT jacks on

the DVD/VCR and to the red and white AUDIO IN jacks on the TV.

Connect the yellow video cable (supplied) to the DVD/VCR VIDEO OUT jack on the DVD/VCR and to

the VIDEO IN jack on the TV. The VIDEO IN jack on the TV is usually yellow and may be labelled CVBS, Composite,

or Baseband video.

Plug the power cords of the DVD/VCR and the TV into an active power outlet.

Turn on the TV and set it to the correct Audio/Video In channel.

Press STANDBY-ON y on the DVD / VCR or its remote control to turn on the DVD/VCR. The first

time you turn on the DVD/VCR, you should complete the First-time DVD/VCR Setup. See the other side

of this Quick-Use Guide for details.

H9820UD_QUG_0112 05.1.24 8:08 PM Page 1

PAGE 1
H9820UD_QUG_0112 05.1.24 8:08 PM Page 1 DVP3050R - There are many ways to connect your new DVD / VCR to your Television and other equipment.This Quick-Use Guide shows the easiest, most common connection. Higher quality connections are explained in the accompanying owner’s manual and will provide better sound or picture if your TV and/or audio system is compatible.
PAGE 2
H9820UD_QUG_0112 05.1.24 8:08 PM Page 2 Quick-Use Guide (cont’d) First-Time DVD/VCR Setup 1 2 1 Turn on the TV and set it to the correct Audio/Video In channel. Press VCR, then press STANDBY-ON y. VCR light will appear on the front of the DVD/VCR. The TV display shown below will appear.