User manual

73
EN
Yo u have inserted the batteries supplied in your remote control.
Yo ur receiver is connected to the satellite antenna,TV set and other equipment
according to one of the diagrams in chapter 7.
- Switch on your TV set and select the appropriate HDMI input (refer to your TV set
user manual).
- Plug the receiver’s power supply cord into the mains.The receiver display indicates
, then .
- Press V-Output once, then check the receiver display indication:
• If is displayed, check that the welcome screen displays
o
n your TV screen.
• if is displayed instead, successively press V-OUTPUT
until the source selected matches your connections as described in
paragraph 7.1 and the welcome screen appears on your TV screen.
- Press P+ then P-.Wait for a few seconds for the First Installation screen to appear.
8.1 Installation settings
- Select your favourite language.
- Select your country.
- Check for adequate signal strength and quality.
To install ASTRA 19.2° East:
- Press OK to start searching for channels broadcast on the ASTRA 19.2° East
satellite.The Installation screen appears.
- Proceed to paragraph 8.2.
To install ASTRA 19.2° East and other satellites:
- Press EXIT to access the Antenna Configuration screen.
- Select antenna settings as described in paragraph 14.6.1.
- Press OK to start searching for channels.The Installation screen appears.
- Proceed to paragraph 8.2.
If you press EXIT during the scanning process, you interrupt the scanning and
go back to the previous screen.In this case, none of the channels found are stored.
8.2 Channel search
Once the scan has been successfully completed, a completion message is displayed.
- Press OK.
A new screen appears, with a message indicating that a search for new, upgraded
software is in progress:
- Either wait for software detection,and then proceed as indicating on screen. It is
recommanded to accept software so as to keep your receiver up-to-date.
At the end of the first installation, the receiver tunes to the first channel in the
main TV list.
- Or press EXIT to stop searching for new software and tune the receiver to the
first channel in the main TV list.
8 First installation