User manual

189
ENGLISH
Menu
Example:
Country selected is germany
Menu language selected is Turkish satellite is
TURKSAT
In this case, deactivate Automatic Time Updates
(OFF).
Local Time is German
Time Zone is GMT+2 hours for the summer
time and GMT+1 for winter tim
8.1.4 Antenna Settings
Select appropriate values for the following:
• Installation type:
- Dual if two satellites/2cables or 1 satellite/2
cables, each tuner is then installed separately
- Loopthrough if one satellite/one cable only or
two satellite/one cable (unicable/dual LNB).
o Loopthrough 1 2 if cable from the
satellite is connected to the LNB In of the
Tuner 1. LNB out of the Tuner 1 is then
connected to the LNB In of the Tuner 2 by
means of the short RF cable.
o Loopthrough 2 1 if opposite situation
• Tuner: If you have selected the installation
type “Dual”, the options Tuner 1 and Tuner 2
are displayed.You can now differently define
the characteristics for both Tuner, e.g. adjust
both Tuner to the different satellites.
• LNB Type: Set the LNB type Universal if your
LNB is a standard LNB, Unicable if your LNB
is a Unicable LNB. If Unicable LNB is chosen,
refer to chapter Advanced Unicable settings to
configure the 4 settings:Tuner 1 IF, Channel
ID,Tuner 2 IF, Channel ID.
• Satellite:
- Select the desired satellite: default setting is
ASTRA 19.2° East
- (The lower half of the display will show a bar
graph indicating signal strength, and will also
indicate the signal quality of a TV channel
found at this satellite position.The larger the
signal graph is, the better the signal quality.)
• Primary DiSEqC: If the satellite installation
is equipped for switching by means of DiSEqC
commands, the DiSEqC position of the LNB
can be entered here (up to four LNB’s
designated A, B, C or D).
8.1.5 Channel Search
• Satellite Search
Use the automatic program search to allow
your receiver to search through an entire
satellite range for new programs. In this case,
the entire frequency range of the satellite is
searched.The following information must be
configured:
- Satellite: Select the satellite position to be
searched. Below this you will see a display of
the current signal strength.
- Initiate the automatic program search by
pressing the red function key.
- Newly found programs will be displayed one
after the other on the following page.This
can take a couple of minutes.
- When the result of the program search will
be displayed, save the newly found programs
with the Green key, or discard them by
pressing the Red key.
Note:The search procedure can be
terminated at any time by pressing the “EXIT”
key.The response may not be immediate.
• Channel Search
New digital satellite TV and radio programs are
added almost on a daily basis, or existing
programs change their frequency. If you wish to
receive these programs, you must allocate them
to specific program slots in the program list,
and store them in memory.The program search
function is designed to assist you in this activity,
and there are various types of program search
available.
Several procedures can be followed in order to
initiate a program search. Press the “Menu” key