WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2} this device must accept any interference received, including interference that may cause undesired operation. NOTE This equipment has been tested and found to comply with the limits for a Class B digits! device, pursuant to Part 15 of the FCC Rules.
ENGLISH INTRODUCTION CDD3610 is a new generation Half Height 525' Builtin CDRecordable/ReWritable drive with the popular (Enhanced IDE interface. ‘The drive is in fact a mild-fungtion device, since it can be used as: o fast CD-ROM reader (up to 6.5x speed) * Ix and 2x speed CD-Recorder, e.g.
ENGLISH Features of the CDD3610 drive: * Multi-function device (CD-ROM reader, CD-Recorder and CD-Re Writable drive) » Supports Incremental Packet Wii ting for data storage applications and “drag & drop® File System support through the CD-UHF standard (endorsed by Optical Storage Technology Association or OATS) » Supports standardized Multi Media Command set (MMC) as standardized by the American National Standards Institute (ANS * Plug & Play read compatibility under Windows 95 and Windows NT' + Interfaces
INSTALLATION Precautions This drive, like alf electronic equipment, is static sensitive, * Please take the proper precautions when handling the drive, for example by touching the PC chassis before touching the drive, » Avoid touching the IDE connector pins as well as the interconnection ping and the jumper pins.
5 i " ENGLISH Installing the drive Tums off your computer, | monitor and other peripherals. To disconnect your configuration completely from the mains, the mains plug has (o be:disconnected. OPEN THE COVER FLAP OF THIS BOOKLET FOR LOCATING THE DRIVE-CONNECTORS AND THEIR ORIENTATION. Remote the cover fom your computer. Please consult the manuals that came with your computer for specific details.
: Fro R AN ENGLISH @ In order to mount the drive inside your FC (or other type of computer), locate freesia horizontal 5,25% bay and follow the instructions, as provided with your computer systems, for installing the drive! ‘You have several possibilities to install your IUE data cable depending on your existing configuration: A) Hard-Disc connected as Master (o Primary IDE Port, CD-ROM connected as Master to Secondary IDE Post: Connect CDD3616 as Slave t© Secondary IDE Post, = Ry P Configuration.
m i ENGLISH (8) ovate the free end of the IDE data cable and thread it out through the open drive bay. Do the same with the power cable and the (optional) audio cable. Audio IDE Cable Duse Cole Connect your (option Ad audio cable, IDE data cable and the power cable into the Back of the CDD3610. Make sure you correctly align pin 1 of the cable to pin 1 of the connectors.
] ENGLISH ! @ Insert the CDD3610 into the drive bay. Using all the screws included in the bag to secure the CDD3610 into the bay, Replace the cover. Connect the mains glop of your configuration, When you have successfully installed the drive and established all connections, it is now ime to switch on the PC. You are ready 1o run the reservist (See appendix) and then install the software.
ENGLISH Summary OF CONTROLS AND CONNECTIONS Front view (See Cover Flap Fig.1) L 3. HEADPHONE PLUG Connect your headphone o listen to audio or music discs {or tracks). HEADPHONE VOLUME CONTROL Tum the wheel t© the right 10 increase the audio volume of your headphone. WRITE INDICATOR Lights “orange” when writing of a disc occurs. Flashes “orange” during write emulation. DISC TRAY DISC IN/ACTIVE/ERROR indicator (dual color LED) Lights “green” when 4 disc is present.
Rear view (See Cover Flap Fig.1) 8. . AUDIO LINE OUT CONNECTOR 4321 1: Left 2 GND 3 GND 4: Right JUMPER BLOCK ENGLISH ‘These jumpers are used o select Master/Slave mode and Cable Select (See Appendix for more information). IDE CONNECTOR 40 pin IDE flat cable connector (See Appendix for more information). 10.
ENGLISH OPERATING/ TESTING YOUR SYSTEM Loading and unloading a disc @ To open the tray: Press the Open/Close button. Load a disc, with the label facing upwards, The tray accommodates discs with 8 em diameter (CD-Single) or the more usual 12 em digs. OPEN/CLOSE Button To close the tray, either push gently at the front of the tray or press the Open/Close bison. FOR OFFICIAL RESULTS, USE Phi Ups CD-R ok CD-RE MEDIA. DON'Y USE GENERAL PURPOSE COMMERCIAL HEAD CLEANING DISCS.
.. ENGLISH DO NOT $WITCH OFF THE COMPEER AND/OR THE DRIVE DURING THE RECORDING PROCESS, SINCE THIS MIGHT RESULT BV AN UNREADABLE D $C, PLEASE MAKE SURE THAT THE COMPUTER HAS FINISHED 1T°6 RECORDING PROCESS AND TRAY THE WRITE INDICATOR ON THE PRINT OF THE DRIVE IS OFF. Operating the on the computer specific Application Software e ruining on the computer platform in use, designed to work with the Philips CDD3610, must be used in order to be able to operate the CDD3610 correctly.
e ADVERTISE 1Ee _ R ENGLISH ADDITIONAL INFORMATION Care of discs . When loading a disc, allow dme for the door 10 open and then gently insert the disc. . Handle discs only by the outer and inner edges. » Never write with a chipolata on the surface of the disc. * Do not store a disc in places with high temperature and humidity. Do not place the disc under direct sunlight. Store discs in their cases to prevent dust contamination, scratches, bending and other damages. .
Technical data PERFORMANCE Capacity 120mm disc 80mm disc Access time average 1/3 datal® Access time max(Z) Data-transfer-rate (corresponding) Data-transfer-rate (read only) Max, busts rate Interface Form factor Daa integrity from drive, assuring new discs Data buffer Disc loading ENGLISH ! 600 Mbytes/700 Bytes 200 Bytes 350 sec. < 730 see.
-y ENGLISH DIMENSIONS Height: 41.5 mm (1.64 inch) Width: 146 mm (5.75 inch) Depth: 206 mm (8.1 inky WEIGHT Jess then 1 kg POWER DISSIPATION max. 8W Power Supply: g Voltage requirements: . +12V (596 Current requirements: | +12V 160 mA typ. 200 mA max. max. ENVIRONMENTAL Operating temp?) 104 °F) Non operating temp 251070 € (-13 10 158 °F) RELIABILITY MT BF (hours 20% duty cycle) 120,000 POH MEDIA CD-R conform to “Orange Book” part If {CD-Record able) and part I {CD-Tableware.
APPENDIX Jumper Block N ENGLISH Romper otk * When a shorting jumper is in the *C8" (CHISEL) position, the device will use the bots interface signal CHISEL to configure the device. Jumper Block C Ism s + When the shorting perjurer is placed in the *M* (MASTER) or 8% (SLAVE), the drive will be configured accordingly.
Auto self test » The auto self test will execute a number of diagnostic tests and will be activated by pushing and holding Open/Close button for one complete Open/Close cycle of the tray, * The auto self test can also he executed by holding the Open/Close button for abut 4 seconds during power-up. The disc-in LED and the write-LED will be tested before the actual self test: ~The disc-in LED will flash three times: The fist time RED, the second time GREEN and the East time ORANGE.
! m1 . ENGLISH Example : Execration of test amber 4 « disc-in LED is ORANGE » Test 4 is being executed o disc-in LED flashes 4 times GREEN » ‘Test 4 is executed successfully OR « disc-in LED flashes 4 times RED » Test 4 failed « After completion of the wholeheartedness, a final indication of the test results will be given: The LED will flash GREEN-ORANGE for about 3 seconds if the test is successful. Otherwise, the LED will be RED until a new command has to be executed.
ENGLISH Basic principles of CD-R media A blank CD-R disc is divided into areas (see figure below), This differs from a prerecorded dies by the additional CD-R area, which lies in front of the lead-in area. Oriole Additional CD-Area Lead-out track A CROSS-SECTION THROUGH A CD-B DISC The disc comprises different layers. Protective area Reflective layer (gold) Elastic substrate I Preformed tracks * Transparent plastics material (the same as conventional CI's) is used as the substrate.
oo KIDNAPPER ENGLISH « Onto this a special greenish tinged transshipment layer is applied. The substrate hds already been provided with a preformed track spiral into which the data will be written during recording. « On top of the green recording layer is a reflective gold Layer and 2 protective layer of plastic material.
= PENDENT ENGLISH A CROSS-SECTION THROUGH A PARTIALLY RECORDED CD-R DISC. Alter the first recording the recording area fs divided (see figure below). Recorded area Unrecorded area hole 18 Leaden » The “Lead-in”, “program area” and “Lead-out” areas are present on every conventional prerecorded CD. » For the palatially recorded CD-R disc, the PCA and PMA areas are incorporated in front of the Lead-in. * Track numbers with associated absolute start and stop mes ase stored in the PMA.
ENGLISH A CROSS-SECTION THROUGH A FULLY RECORDED CD-R Dis C. The fully recorded CD-R disc has 2 program of 74 minutes playing time, a lead-in area with table of contents and a lead-out area. maz, 59 mm max, 58 mm 2590 mm 33,00 um "] Oe.me Recorded aces hole Lead-in Lead-out + The areas specific to the CD seconder, the PCA and PMA, are stifle present but are simply not used by conventional CD players.
ENGLISH Glossary of terms CD-RE THE BEST WAY TO CREATE YOUR OWN CDs WITH RE-USABLE CD-BE. » CD-Re Writable (CD-RE) gives you the opportunely to create your own CDs, in the best and most cost-effective way. CD-RE is, in fag, the logical extension of the promise already made by Philips CD-Record able Together, they give you the opportunity to ron the media that best suits the job in hand. .
* For compatibility, drives need to do this in 2 standard way, They also need to interface and interact with their host computer systems in a standard way. * That standard way is Multi Read, And any CD drive can play all CD media CD-Digital Audio, CD-ROM, CD-R, and CD-RE provided that it supports Multi Read. * What is more, Multi Read extends the same compatibility to DVD. All DVD equipment that supports Multi Read will also be able to retrieve CD-RE data.
¢ REBEL ENGLISH WHAT 1§ THE ORANGE BOOK? » The Osage Book is 2 document that describes the specification for CD-Write Once (CD-Record able) technology developed by Philips and Sony.
ENGLISH A session is defined as an aces including lead-in, program data and lead-out, « A YD-R recorder they supports multi session recording can write 4 disc that wil have multiple sessions linked together, each containing their own lead-in, program and lead out. * Any multi session-supported CD reader can access the data, whether it was written in the first session or a subsequent session.
ENGLISH Com Pact Dis C AVERAGE TRANSFER RATES Note 1: The normal CD transfer rae from the disc is 75 blocks per second. Note 2: The average transfer wares shown are in BYTES PER SECOND.
ENGLISH ! « Duse at Once is a writing mode that requires data o be written continuously, without any interruptions, until the entire data set is transferred to the CD-R. WHAT IS “DISC AT ONCE"? . The lead-in, program and lead-out are written in a single event. All of the information to be recorded needs to be staged on the computer’s hard disk prior to recording in the Disc at Once mode. This mode is usual preferred for discs that are sent to 2 CD-ROM replication facility when CD-R is the source media.
Wv ENGLISH * A track written “at once” has 150 blocks of overhead for run-in, RN-out, per-gap and linking, Packet write, on the other hand, is 2 method whereby several write events are allowed within a track, thus reducing the overhead. These “packets” are bounded by 7 blocks for mun-IA (4, MN-out €2) and Yok (1), WHAT’S THE DIFFERENCE BETWEEN A “MULTI SESSION” DISC AND A “MULTIRACIAL” DISC? * A “session” is 2 unity on @ CD which is bounded by lead-in and lead-out.
ENGLISH For other information on Phi ips products, please consult the following BBS (Bulletin Board System) or Internet sites: Other information BBS: +31/40/273 1112 Internet (SAY hetpe/fwrww, pps. philippic Internet (worldwide) EUROPEAN SUPPORT NUMBERS Austria 0660-8142 Belgium 0800-15532 Denmark BOA-17941 Finland 0800113170 France 0800217909 Germany 0130-823983 Greece 00800-311207 Ireland 1-800-553178 leaky 1678.